Foiresoft BAFY19kBU8w No Tools Pleated Fabric Shades User Guide
- June 17, 2024
- Foiresoft
Table of Contents
PLEATED SHADES
USER GUIDE
GETTING STARTED
-
INCLUDED COMPONENTS
The amount of the fixing
clip might differ depending on the width size of the shades. -
TOOLS YOU MAY NEED (NOT INCLUDED)
-
CHOOSE YOUR MOUNTING TYPE
HOW TO MEASURE
INSIDE MOUNT
WIDTH
Measure the inside of your window frame to frame horizontally. It is
recommended to measure the exact size of the inside of your window frame.
HEIGHT
Measure the inside of your window frame to frame vertically. It is recommended
to measure the exact size of the inside of your window frame.
OUTSIDE MOUNT
WIDTH
Measure the outer-most points where you want your shades to be installed. For
better light control, we recommend to give bigger space than your window
frame.
HEIGHT
Measure vertically to where you want your window to be covered. It is fine to
measure until the end of your window frame, but if you want more coverage, you
can add few more inches to the measurement.
NOTES : Regarding of your mounting type, we recommend to buy one larger
size in height than your window measurement. i.e. if your window height is
[H64 inch], we recommend you to purchase [H72 inch]
HOW TO INSTALL
INSTALLING TIPS
- Make sure the shade are fully folded to ease cutting it.
- Confirm the direction of the front and back side of the shade before installing.
- Check if there are any dust or poluted area at the mounting suface.
- We recommend to install the shades on flat/smooth surface for better adhesion.
-
Cut the blind
Measure the width size you want to cover precisely before cutting the blinds. -
Peel the double-tape
Remove the double-tape attached on the top of the blinds before sticking it to your window. -
Stick to your window
Press firmly when attaching the blinds and make sure all the tape are sticked properly. Please check the front and back side of the shade before installing (Refer to the picture).
HOW TO USE VELCRO TAPE
- Cut the velcro tape into 2 or 3 pieces
- Attach velcro tapes to the shades and window frame
HOW TO USE FIXING CLIP
- Use the fixing clips to raise and lower the height
PRECAUTIONS
- Before installing it is recommended to check the purpose of usage and the location to install the shades.
- Please Checkup for foreign substances and the surfaces to be attached. We only recommend to install the shades on flat and clean surface, not surfaces where the shades might not stick well.
i.e. Wood frame, Cement wall, Uneven and bumpy surface, etc
CLEANING GUIDES
| 01 DO NOT WASH
---|---
| 02 DO NOT USE CHEMICAL
| 03 DO NOT IRON
How to remove stain
Use soft brush to remove dust. Please do not use any wet equipment to clean
the shade.
CONTACT INFORMATION
Foiresoft Customer Service :
https://m.site.naver.com/1bb0B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>