reolink RLN12W 12 Channel Wi-Fi 6 NVR 247 Recordings User Guide
- June 17, 2024
- reolink
Table of Contents
RLN12W 12 Channel Wi-Fi 6 NVR 247 Recordings
User Guide
What’s in the Box
NVR Introduction
- HDD LED
- USB Port
- Power LED
- Reset
- Power Input
- USB Port
- HDMI Port
- LAN Port (For IPC)
- VGA Port
- Audio Out
- LAN Port(For Internet)
Different states of the status LEDs:
Power LED: Solid green to indicate the NVR is powered on.
HDD LED: Flashing red to indicate the hard drive is operating properly.
Connection Diagram
-
Connect the included power adapter to the NVR and a power outlet.
-
Connect the NVR to your router with an Ethernet cable (if you hope to use it remotely).
Next, connect the mouse to the USB port of the NVR.
-
Connect the NVR to the monitor with a VGA or HDMI cable.
NOTE: There is no VGA cable and monitor included in the package. -
Follow the steps on the monitor to complete the initial setup.
NOTE: In the second step, UID is disabled by default. You’re recommended to enable it for remote access on smartphones or computers. Or you can set it later in “Settings > System >Info”.
-
Power on your WiFi cameras and connect them to the LAN ports (for IPC) on the NVR via Ethernet cables.
-
Click Sync WiFi Info to connect the cameras to the NVR’s WiFi.
-
After the sychronization succeeded, remove the Ethernet cables and wait for a few seconds for them to be reconnected wirelessly.
-
After the wireless connection is successful,the cameras can be installed at the desired location.
NOTE: There are no cameras included in the package.
Access the NVR via Smartphone or PC
- Connect the NVR to a router using the included Ethernet cable.
- Download and launch the Reolink App or Client and follow the instructions to access the NVR.
• On Smartphone
Scan to download the Reolink App.
• On PC Download path: Go to https://reolink.com>Support>App&Client.
https://reolink.com/wp-json/reo-v2/app/download
Mount Tips for the Camera
Installation Tips
- Do not face the camera towards any light sources.
- Do not point the camera towards a glass window. Or, it may result in poor image quality because of the window glare by infrared LEDs, ambient lights or status lights.
- Do not place the camera in a shaded area and point it towards a well-lit area. Or, it may result in poor image quality. To ensure best image quality, the lighting condition for both the camera and the capture object shall be the same.
- To ensure better image quality, it’s recommended to clean the lens with a soft cloth from time to time.
- Make sure the power ports are not directly exposed to water or moisture and not blocked by dirt or other elements.
- With IP waterproof ratings, the camera can work properly under conditions like rain and snow. However, it doesn’t mean the camera can work underwater.
- Do not install the camera at places where rain and snow can hit the lens directly.
- The camera may work in extreme cold conditions as low as -10°C. Because when it is powered on, the camera will produce heat. You may power on the camera indoors for a few minutes before installing it outdoors.
NOTE: Please install the cameras within the NVR’s signal range.
Troubleshooting
Camera Not Displaying lmages on the Monitor
Cause 1：Camera is not Powering on
Solutions:
- Cover the camera’s IR LEDs to see if they light up.
- lf you have a 12V power adapter, power up the camera with the power adapter.
Cause 2：Incorrect Account Name or Password Solution:
Login to the NVR, go to Settings > Channel page and click Modify to input the
correct password for the camera. lf you forget your password, please reset
your camera to reset the password to default (blank).
Cause 3：Camera is not Assigned to a Channel
Solution:
Go to Settings > Channel page, click the channel you want, and then select
your camera for that channel. If all channels are already in use, please
delete the offline camera from the NVR. Then the channel this camera was taken
is free now.
Cause 4：No WiFi After Removing the Ethernet Cable
Solutions:
- Connect the camera to the NVR with an Ethernet cable. Go to Network > Wi-Fi > Settings on the monitor to sync the NVR’s WiFi.
- Install the camera within the NVR’s signal range.
- Install antennas on the camera and the NVR.
If these won‘t work, please contact Reolink Support https://support.reolink.com
Specification
NVR
Operating Temperature: -10°C to 45°C RLN12W Size: 255 x 49.5 x 222.7mm Weight:
1.4kg, for RLN12W
Notification of Compliance
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
ISED Compliance Statements
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
ISED Radiation Exposure statement
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20 cm between the radiator and your body.
Simplified EU Declaration of Conformity
Reolink declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and
Directive 2014/30/EU. WiFi Operating Frequency
OPERATING FREQUENCY :
2.4 GHz EIRP < 20dBm 5 GHz EIRP < 20dBm 5.8GHz EIRP < 14dBm
The functions of Wireless Access Systems including Radio Local Area
Networks(WAS/RLANs) within the band 5150-5350 MHz for this device are
restricted to indoor use only within all European
Union countries (BE/BG/CZ/DK/DE/EE/IE/EL/ES/FR/HR/ IT/CY/LV/LT/
LU/HU/MT/NL/AT/PL/PT/RO/SI/SK/FI/SE/TR/N O/CH/IS/LI/UK(NI)
UKCA Declaration of Conformity
Reolink declares that this product is in compliance with Electromagnetic
Compatibility Regulations 2016 and Electrical Equipment Safety Regulations
2016.
Correct Disposal of This Product
This marking indicates that this product should not be disposed with other
household wastes.throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmentally safe recycling.
Limited Warranty
This product comes with a 2-year limited warranty that is valid only if
purchased from Reolink Official Store or a Reolink authorized reseller.
Learn more: https://reolink.com/warranty-and-return/.
Terms and Privacy
Use of the product is subject to your agreement to the Terms of Service
and Privacy Policy at reolink.com. Keep out of reach of
children.
@ReolinkTech https://reolink.com
58.03.001.0350
References
- Reolink Official: Security Cameras and Systems for Home & Business
- Reolink Official: Security Cameras and Systems for Home & Business
- Warranty & Return – Reolink
- Reolink Support - Official Reolink Help Center
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>