ROCKVILLE RWS10CA Slim 10in Amplified Powered Car Subwoofer Enclosure User Guide
- June 17, 2024
- RockVille
Table of Contents
ROCKVILLE RWS10CA Slim 10in Amplified Powered Car Subwoofer Enclosure
WIRING GUIDE
Scan the QR codes or go visit the URLs to access how-to video(s), the wiring guide, and other important information you may need to get the most out of your item.
FEATURES
-
High-Level inputs (used with factory head unit or if the head unit has no RCA outputs):
these inputs, also referred o to as speaker-level inputs, allow you to connect to the factory speaker wires. They are called High-Level inputs because they convert the high voltage running through the factory speaker wires to a voltage the amplifier can handle. These inputs will provide the end user with clean, well-defined sound for optimal musical enjoyment. -
Bass Remote:
Connect dashmounted bass remote (included) via RJ11 cable included). -
RCA Input Connect to your head unit’s RCA outputs.
-
Gain control:
The Gain control tunes the amp’s input stage to accept the head unit’s RCA output voltage level. Tum it counterclockwise to the MIN position. Adjust the head unit’s volume -
Low Pass Crossover control:
Adjusts the frequencies, between 40Hz – 250Hz, that the sub will play. Whatever you set it to, the sub will only play frequencies below that setting. &. -
Power LED:
Indicates proper voltage and power. Protect LED: Indicates a diagnostic condition (power connections, blown fuse, too high input, or internal failure). -
Power connections:
See the Wiring diagram for proper setup. -
Fuse
HIGH-LEVEL INPUT
WIRING
RCA INPUT/BASS REMOTE
©2024 ROCKVILil // The information presented is subject to change and/or improvement without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>