INNOVA SW-15 Smart Watch Fitness Thunder User Manual
- June 17, 2024
- InnOVA
Table of Contents
INNOVA SW-15 Smart Watch Fitness Thunder
FEATURES
Recommendations for people with sensitive skin during use of electronic wrist devices, Smartwatch and Smartband.
The materials used for our INNOVA Smartwatches and Smartbands are selected
following a rigorous control of hypoallergenic measures, as well as
guaranteeing that all materials comply with current regulations for materials
in contact with the skin.
A small number of people, however, may experience some type of skin reaction.
If you suspect, or know, that you are allergic or have an above average
sensitive skin type, you should monitor the use of these devices for any type
of reaction due to said allergies, environmental factors or prolonged exposure
to irritants, like soap, sweat, or other causes.
Smartwatches and Smart bands may contain materials such as nickel and
acrylates which, even though they are within the permitted amounts in the
manufacturing process, may cause skin to react if you are sensitive to them.
If you use these devices for a prolonged period of time, you may be more
susceptible to developing skin sensitivities. To avoid possible skin
irritations we recommend you do not expose the device to chemicals or use it
if your skin has, or has been recently applied with, any of the products
listed below:
- Insect repellents
- Moisturizing creams and lotions
- Oils
- Perfumes
- Antiseptic gels
- Soaps
- Sun protection creams
It is recommended that the devices are used when the skin is completely dry
and free of any of the aforementioned products to avoid having charging
contacts and measurement sensors in contact with wet skin. They are not
submersible or waterproof.
Clean the device thoroughly to remove sweat after training and allow it to
dry. Prolonged exposure to moisture can cause skin irritation.
It is also advisable not to wear these devices too tight or too loose. If the
strap is too tight, it may cause skin irritation. If the strap is too loose,
chafing may occur.
The watch strap should be left so that it can move slightly back and forth on
the wrist.
If you wear the device for prolonged periods of time, remove it to give your
skin a rest. To avoid irritation, swap the device to your other wrist.
If you notice redness, swelling, itching or any other irritation, remove the
Smartwatch immediately and consult your physician before using the device
again. Special attention must be paid to the use of these devices in places
with relatively low humidity conditions.
When using the Smartwatch/Smart band in places with low relative humidity
(dry/poorly ventilated places, low humidity atmospheric conditions, dry
indoors, if heating or air conditioning is always on, etc.), as with any other
electronic device, it may be affected by charges of static electricity on rare
but certain occasions. This may cause damage to the device and also to the
person wearing it at that time. Static electricity is everywhere. It surrounds
us without us perceiving it. An effective trick to avoid a high percentage of
static electricity at home:
- Use a humidifier.
Humidity is a good conductor of electricity therefore, by maintaining an
acceptable percentage of it, we will avoid static in areas of the home where
we metal objects may be found. Small containers of water on top of radiators
is another alternative solution.
The use of the devices in bed, whilst sleeping, is especially discouraged for
children and the elderly due to the fact that repeated movements during the
night may cause, through friction with sheets, blankets, etc. a charge of
static electricity. This may result in a sudden discharge of the watch’s
battery and/or heating of same as the human body is a conductive element and
can cause a reaction to people with sensitive skin, redness, irritation, etc.
If you notice redness, swelling, itching, or any other form of irritation,
remove the Smartwatch immediately and consult your physician before using the
device again in case you are suffering from any type of reaction, allergic or
otherwise.
INNOVA CELLULAR
Thank you for using our smart watch INNOVA.
Important! The data provided by the smart watch, such as heart rate, blood
oxygen and blood pressure, are merely indicative, it is not an exact medical
measuring device.
Even if you are well, go to all the appointments scheduled by your doctor.
Welcome to use our high-performance wristband smart bracelet which creates
thoughtful and health experience for you.
Device maintenance
Please remember the following tips when you maintain your smart bracelet:
- Clean the smart bracelet regularly, especially its inner side, and keep it dry.
- Adjust the smart bracelet tightness to ensure air circulation.
- Excessive skincare product should not be used for the wrist wearing the smart bracelet.
- Please cease wearing the smart bracelet in case of skin allergy or any discomfort.
Schematic diagram of main body of the smart bracelet
Power-on
Long press the side button for 3 seconds or plug in the charging clamp to
charge the smart bracelet.
Downloading and binding of smart bracelet APP
Note: your mobile phone must support Android 5.1 or IOS 8.0 or above, and
Bluetooth 4.2 or above.
- Download from Apple Store or Google play and install APP or scan QR code with mobile phone to download APP.
|
|
---|---|---
2. Pairing smart bracelet with APP:
Please do not pair the watch directly to your phone’s Bluetooth. If you have
already performed this operation, please remove it from the list of paired
devices as it will prevent the connection to the APP.
1. Open the APP
2. Update your personal details (gender, birth year, etc.) and press the check mark. Once done, grant all permissions requested by the APP.
3. To link the watch to your phone press “To Add”. 
4. The phone will search, and display, SW-15. Select it to pair the watch to your phone. Once synchronization is complete your watch will display local date and time.
5. When you press the watch icon (bottom middle) you will see the following screen: Here you can set up notifications, alarms and the background image (can be
personalized). In “Others” you can establish time format (12/24 hours),
reminders, etc.
6. The last icon, on the lower right, will show “My” screen. Here you can complete the details of your profile and establish your objectives. 
Introduction of smart bracelet functions
Power-on status switch the menu interfaces of main screen, as the interfaces
shown in the following;
Remove Device
For the Android mobile phone, the device can be disconnected from your mobile
phone by simply clicking on Remove device.
For Apple mobile phone after binding removal, you need to click on the symbol
on the right in Setting- Bluetooth, and choose to ignore the device. As shown
below:
Frequently Asked Questions (FAQs)
-
Why does the smart bracelet automatically disconnect Bluetooth when the Android screen goes out?
-
Lock background APP. When the Da Fit process is cleared, the smart bracelet will be disconnected from the mobile phone.
-
Set APP self-startup
-
Unrestricted background operation. The Android mobile phone installed with APP intelligently restricts the background operation by default, and App should be set manually without any restriction.
-
Why cannot the smart bracelet receive message push?
-
Please confirm that you have turned on the switch for message push at the mobile phone client.
-
Please confirm that messages can be displayed normally in the mobile phone notification bar. The message push on the smart bracelet is completed by reading the message from the mobile phone notification bar. The smart bracelet will not receive the message push if there is no message in the mobile phone notification bar.
(You need to find notification settings in the mobile phone settings, and turn on the notification switch of WeChat, QQ, call, SMS and mobile phone client). -
Turn on the mobile phone — Settings. Enter “Notification use right” on the top search box, re-open Da Fit.
Why can’t take a bath with the smart bracelet?
the smart watch is resistant to splashing water but is not waterproof
Warning:
Please consult your doctor before you take a new sport.
The smart bracelet should not be used for any medical purpose though it may
dynamically monitor the heart rate at real time.
Note: Do not expose the smart watch at extreme temperatures, the battery
could exploit.
Features
Exercise recording (step counting, distance, calories) / Exercise mode /
Notifications (call, whatsapp, message…) / Heart rate monitoring / Sleep
monitoring / Stopwatch / Camara control / Music control / Alarm / Screen 1.4
inches color / Full screen touch /
Valid for iOS and Android / Bluetooth 4.2 / Capacity battery: 170 mAh / Life
time: about 5 days of use and about 25 days of standby / APP “Da Fit” / No
waterproof / Bluetooth frequency band: 2.4 Ghz / Maximum emitted RF power <
100 mW
Customer service
Only in English, Spanish and Portuguese
Customer Service: +34 91 713 94 98
Working hours: Mon to Thu from 08:00 to 14:00 and from 15:30 to 17:30 and Fri.
from 09:00 to 14:00
[email protected]
Declaration of conformity
Through this INNOVA CELLULAR, it declares that the INNOVA SMART WATCH
FITNESS THUNDER (SW/15 (P8)) complies with the essential requirements and any
other applicable or enforceable provisions of Directives 2014/30/EU,
2014/53/UE (RED) and RoHS 2011/65/EU annex II amending annex (EU) 2015/863 and
amending annex (EU) 2017/2102
To see the complete declaration of conformity, you can access it through the
following link:
http://www.innovacelular.com/images/web/descargas/descargas/declaracion/declaracion_sw-15.pdf
Guarantee
NOTE: The INNOVA SMART WATCH FITNESS THUNDER (SW/15 (P8)) It has a 3-year
warranty from the date of purchase.
Special importance in the durability of the products have the elements that
compose it and that suffer from degradation and loss of capacities due to
their use, being understood as normal wear that they lose capacity, especially
in the case of
rechargeable batteries, depending largely on infinity of external factors
(hours of use, charge and discharge cycles, use of inappropriate chargers,
temperatures of use, not respecting the recommended charging times, etc…) For
the guarantee of wear and tear parts, it must be taken into account that the
loss of autonomy of the battery as a result of its aging does not imply a
manufacturing defect, so it is considered considered normal that after 6
months have a loss of 10%, at 15 months 20% – 30% at 24 months 45%, all
corresponding to proper use of the battery and the charge and discharge cycles
carried out.
Any battery that presents symptoms other than those listed in this manual,
will be inspected by the technical service and assessed for its affectation to
guarantee. If after 24 months from its purchase the battery presents symptoms
different from those detailed, it will be understood to be exempt from
guarantee for the reasons stated above and will be left out of the inspection
process, becoming the customer who, if they so wish, must reliably demonstrate
that the battery presented defects other than those detailed in this manual
before those 24 months.
+34 91 713 94 98 INNOVA CELULAR SL C/ Severo Ochoa Nº 9 nave 8B 28521 Rivas-
Vaciamadrid Madrid
Safety warnings
Important Safety Information : Handle the Smart Watch with care.
They contain sensitive electronic components, including batteries, and may
malfunction, affect performance, or cause damage if dropped, burned,
punctured, crushed, disassembled, or exposed to excessive heat, liquid, or
high-pressure environments. concentrations of industrial chemicals, including
nearly evaporated liquefied gases such as helium. Do not use the Smart Band if
it is damaged.
Batteries: Do not try to replace the battery of the Smart Watch by
yourself, as you could damage the Smart Watch and cause overheating and
injury.
Charge: Charge the Smart Watch with the charging cable and a power
adapter or a computer, charge the device only with an adapter that meets
relevant national, international and regional safety standards. Other adapters
may not meet applicable safety standards and their use to charge the Smart
Watch may present the risk of injury or death. Using damaged cables or
chargers, or charging the device if they are wet, may cause fire, electric
shock, injury, or damage to the case or other belongings.
Prolonged exposure to heat: Avoid prolonged skin contact with the device,
power adapter, charging cable and its connector, or the wireless charger when
connected to a power source, as this may cause discomfort or injury.
Choking hazard: The Smart Watch and the small parts included may present a
choking hazard to small children or cause other injuries. Always keep them out
of the reach of children.
Interference with medical devices: The Smart Watch and charger contain
components and radios that emit electromagnetic fields.
These electromagnetic fields and magnets that the device may contain may
interfere with the operation of pacemakers, defibrillators, or other medical
devices.
Keep a safe distance between the medical device and the Smart Watch.
Request specific information about the medical device from the manufacturer
and your doctor. Stop using the Smart Watch if you suspect it is interfering
with your pacemaker, defibrillator, or other medical device.
Skin irritations: The Smart Watch can cause skin irritation if not cleaned
properly.
Regularly clean the Smart Watch with a soft, lint-free cloth.
In the event of any type of skin reaction, stop using the Smart Watch. If the
problem persists, see your doctor.
Electrostatic discharges: When using the Smart Watch in areas where the
air is very dry, it is easy to accumulate static electricity, so you may feel
a small electrostatic discharge from the Smart Band on your wrist.
To minimize this risk, avoid using the Smart Band in extremely dry
environments, or touch a grounded, unpainted metal object before putting on
the Smart Watch.
Important Driving Information: Discoloration of the connector and the
bottom of the Smart Watch after continued use is considered normal. Dirt,
debris, and exposure to moisture could cause discoloration.
