INNOVA WT11K TIME Reloj Casual Indiana Watch User Manual
- May 15, 2024
- InnOVA
Table of Contents
INNOVA WT11K TIME Reloj Casual Indiana Watch User Manual
Specifications
Digital watch / Works with a button battery / Date and Time / Light / Stopwatch / Alarm / Dial size: 3,2 cm Ø / Strap measurements: 23,5 cm
Indications
-
Do not use in the water or in a wet environment, pre- vent water from entering the watch,
-
Do not use it in extremely boiling or freezing environment.
-
Avoid dropping it onto the ground or shaking it violently, as those might cause damages to the watch.
-
Do not put it near gasoline, detergent, spraying agent, adhesion agent, oil paint, etc. The chemical actions of them might damage the sealing ring ,the watch case and the surface of the watch.
-
You can rinse the surface of the watch with soft cloth and clean water, but do not use chemicals.
-
Do not rinse the painted patterns on your watch forcibly.
-
Do not stretch the watchband too tightly around your wrist. The tightness is reasonable when your finger can insert in.
-
Place the watch in dry environment when unused.
-
The coating of the watch may fade or scuff if it is under pressure long-term touch, abrasion or strong friction.
-
The watchband is made of resin. So if you find any white powder on the watchband, wipe them off with cloth.
The powder does not cause any hurt to your skin or clothes. The watchband may age quickly, crack or break if it bears sweat or dampness. If there is any dirt or drips, wipe them off with soft cloth as soon as possible. -
The watch contains precise electronic element, do not open the cover by yourself. If there is any vapour or drips inside the watch case, please send it to the specialist to be disassembled and repaired.
-
Keep well the operation instruction and the other attached files for future references.
Standard display and button function
Operate and adjust the watch according the following indications on the screen
FUNCTION AND SPECIFICATION
- Standard display: hour, minute, second, month, date, week
- Cold light function
- Stopwatch stage timekeeping function
- Alarm function
- Service temperature: 5º C – 35º C
- Battery: 1.5V high-capacity alkaline Zn-Mn button battery
- Life of battery able to supply power for 18 months approx under the following situation:
– 3 seconds of illumination everyday
– 60 seconds of alarm everyday
OPERATION:
Press “M” button, the mode would change in turn as follows:
M*: When operating in “Stopwatch Function Operation Mode” or “Alarm Time
Adjust Mode”, if “S” or “R” button was pressed before, by pressing “M” button
can back to
“Normal Time Display Mode” directly.
– In “Normal Time Display Mode” : press “S” button to display date; press “R”
button to display alarm time.
– 12/24Time System Display: In “Normal Time Display Mode”, press “M” thrice to
enter into “Time Adjust State”, press “R” button twice to alter into “Hour
Adjust State’, then press “S” button until 12/24 Time System display on
screen, and then press “M” once to back to “Normal Time Display Mode”.
– Time Adjusting: In “Normal Time Display Mode”, press “M” thrice to enter
into “Time Adjust State”, the second value blinks, press “S” to adjust second
value; press “R” button, the minute value would blink, press “S” to adjust
minute value; then press “R” and “S” respectively to adjust hour value, date,
month, week; and then press “M” to back to normal mode.
– Alarm Time Setting: In” Normal Time Display Mode”, press “M” button twice,
then press “S” to set the hour value; press “R” once, then press “S” again to
set the minute value; press “M” to back to normal mode,
– How to use stopwatch: In “Normal Time Display Mode”, press “M” button once
to enter into “Stopwatch Function
Operation Mode”, press “S” button to start timekeeping, press “S” again in to
stop timekeeping, the count value would display on the screen; Press “R”
button to reset, press “M” button to back to “Normal Time Display Mode”.
– How to on/off Alarm, Hourly Chime function: hold the “R” button, then press
“S” to on/off Alarm Function: when
“Alarm On”, the signal would display on the screen, when the alarm ringing,
press “S” to stop ringing, It would ring after 4-5 minutes, press “R” to stop
again-ringing. Hold the “R” button, then press “M” to on/off Hourly Chime
Function.
– Cold Light Lamp: press “L” button to turn on the cold light.
Note: long-term use of cold light would be power consuming.
Declaration of conformity
Through this INNOVA CELLULAR, it declares that the RELOJ CASUAL INDIANA
(WT/11K) complies with the essential requirements and any other applicable or
enforceable provisions of Directives 2014/30/UE y RoHS 2011/65/EU Annex II
amending Annex (EU) 2015/863 and amending Annex (EU) 2017/2102.
To see the complete declaration of conformity, you can access it through the
following link:
http://www.innovacelular.com/images/web/descargas/descargas/declaracion/declaracion_wt11k.pdf
Customer service
Only in English or Spanish
Servicio de atención al cliente / Customer
Service (Español / English): +34 91 713 94 98
Horario de atención al cliente:
De lun. a Jue. de 08:00 a 14:00 y de 15:30 a 17:30 y los Vier. de 09:00 a
14:00
Working hours: Mon to Thu from 08:00 to
14:00 and from 15:30 to 17:30 and Fri. from 09:00 to 14:00
sac@innovacelular.com
Guarantee
NOTE : The RELOJ CASUAL INDIANA (WT/11K) It has a 3-year warranty from
the date of purchase. Special importance in the durability of the products
have the elements that compose it and that suffer from degradation and loss of
capacities due to their use, being understood as normal wear that they lose
capacity, especially in the case of rechargeable batteries, depending largely
on infinity of external factors (hours of use, charge and discharge cycles,
use of inappropriate
chargers, temperatures of use, not respecting the recommended charging times,
etc…)
For the guarantee of wear and tear parts, it must be taken into account that
the loss of autonomy of the battery as a result of its aging does not imply a
manufacturing defect, so it is considered normal that after 6 months have a
loss of 10%, at 15 months 20% – 30% at 24 months 45%, all corresponding to
proper use of the battery and the charge and discharge cycles carried out.
Any battery that presents symptoms other than those listed in this manual,
will be inspected by the technical service and assessed for its affectation to
guarantee. If after 24 months from its purchase the battery presents symptoms
different from those detailed, it will be understood to be exempt from
guarantee for the reasons stated above and will be left out of the inspection
process, becoming the customer who, if they so wish, must reliably demonstrate
that the battery presented defects other than those detailed in this manual
before those 24 months.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>