Modern Ember ME-50-3SV Skyline 50-in 3-Sided Smart Electric Fireplace User Guide
- June 17, 2024
- MODERN EMBER
Table of Contents
Modern Ember ME-50-3SV Skyline 50-in 3-Sided Smart Electric Fireplace
App download
- Download “Tuya Smart” from the app store.
- Scan the QR code.
- Turn on the “GPS” from your mobile device
NOTE
- Make sure your mobile phone is well connected to the nearest WiFi signal.
- Only one device can be paired through the APP at a time.
Login
- Register with your email ID or Mobile phone number as the user name.
- Set up your account password.
Add device
After the account is created, log into the account and select the “Add Device”
button. There are three methods to add your Electric Fireplace.
Method 1: Add by Bluetooth. Open Bluetooth on your mobile phone before
adding.
Method 2: Add Manually on “P0” mode. Please follow below steps A, B, C,
and D.
Method 3: Add Manually on “P1” mode. Please follow below steps A, B, C,
and D.
Add device – Method 1 (Bluetooth)
- Press a button when you see the device named “Modern Ember Skyline Fireplace.”
- Enter the WiFi name and password, and then press the “Next” button for pairing.
IMPORTANT INFORMATION
- Turn on the Bluetooth device with your mobile phone.
- Connect your mobile phone with a WiFi signal.
- When complete, the display on the control panel shows “P4” and the LED ember light shows a GREEN colour and flashes 6 times.
Add device – Method 2 – (PO)
- Press hold U from the remote control or control panel until the display on the control panel shows “PO.” Then follow below steps A, B, C, and D.
- Enter the Wifi name and password and then press the “Next” button for pairing.
- Press the Blink Quickly button for “PO,” device being added:
- When complete, the display on the control panel shows “P4” and the LED ember light shows a GREEN colour and flashes 6 times.
Add device – Method 3 – (P1)
- Press hold U from the remote control or control panel until the display on the control panel shows “P1.” Then follow below steps A, B, C, and D.
- Enter the WiFi name and password, and then press the “Next” button for pairing.
- Press the Blink Slowly button for “P1,” the device being added.
- Select the device’s hotspot (SmartLife-xxxx), and then go back to the device. The device is being added.
- When complete, the display on the control panel shows “P4” and the LED ember light shows the GREEN colour and flashes 6 times.
Complete
Press Done to complete.
APP Operating Instruction
NOTE
Only one device can be paired through the APP at a time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>