OPTONICA FL5883 LED Floodlight User Manual
- June 17, 2024
- OPTONICA
Table of Contents
OPTONICA FL5883 LED Floodlight
Specifications
- Product Type: LED Floodlight
- Suitable for: Outdoor use
- Power Source: Main Line
- Required Tools: Drill, Cross Head Screwdriver, Small Electrical Slotted Screwdriver, Insulation Tape
Daigram
Important Safety Information
Please take time to read and carefully observe the following safety instructions:
- Do not wire this floodlight into the lighting circuit – use a switched fused spur.
- Before installation and servicing, disconnect the electrical supply at the mains.
- Observe all instructions or warnings labelled on or supplied with the product.
- If in doubt, consult a qualified electrician.
Fixing Instructions
Follow these steps to fix the LED floodlight:
- Contact a qualified electrician to install a suitable earth facility for this fitting.
- Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting.
Note
Before proceeding with the installation, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for this product.
General Information
Take note of the following general information:
- Do not mount ceiling/wall fittings onto damp surfaces such as newly painted or plastered areas as this may cause discolouration of the finish.
Tools
Tolls which may be required:
- Drill
- Cross Head Screwdriver
- Small Electrical Slotted Screwdriver
- Insulation Tape
Installation
Follow these steps to install the LED floodlight:
- Fasten the adjustable bracket with stainless steel screws.
- Connect the Main Line to the power wire of the lamp.
- Install the LED Floodlight in the ground, wall, or ceiling.
This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. (Waste Electrical and Electronic Equipment Directive)
FAQ
Q: Can I wire this floodlight into the lighting circuit directly?
A: No, you should use a switched fused spur to wire this floodlight.
Q: What tools will I need for installation?
A: You will need a drill, cross head screwdriver, small electrical slotted screwdriver, and insulation tape.
Q: Can I mount the ceiling/wall fittings on damp surfaces?
A: No, you should avoid mounting on damp surfaces such as newly painted or plastered areas to prevent discolouration.
Q: How should I dispose of this product at the end of its life?
A: Please dispose of this product responsibly by recycling it where facilities exist.
Q: Who is the importer of this product?
A: The importer of this product is Prima Group 2004 LTD, located in Bulgaria, Sofia, Mladost 1, bl. 144, Ground Floor. You can contact them at +359 2 988 45 72.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>