HFCL ion4le Unlicensed Band Radio High Capacity Radio User Guide
- June 17, 2024
- HFCL
Table of Contents
HFCL ion4le Unlicensed Band Radio High Capacity Radio
Introduction
Thank you for selecting io’s Unlicensed Band Radio (UBR), Enterprise / Carrier grade point-to-point and point-to-multi-point solution meticulously crafted to excel in the unlicensed 5 GHz spectrum. Our solution is tailor-made to cater to the connectivity needs of small to medium-sized enterprises, offering exceptional performance for applications spanning short-distance and long- range links.
Packaging Content
Product Overview
installation Set-up
The 2×2 UBR has four threaded holes on its rear side specifically designed for
affixing the mounting bracket. This mounting bracket is designed to facilitate
easy pole mounting by utilizing its components
- Align the L Plate with the holes at the back of UBR and use provided SEMS screws to fix it.
- Position the pole clamp as per the illustration.
- Secure the U-bolt firmly to affix it onto the pole by tightening the hex nuts, as demonstrated in the image below.
- Option to attach the UBR to an external dish antenna using an RF cable, as illustrated in the image below.
- Option to attach the UBR to an external sector antenna using an RF cable, as illustrated in the image below.
Warning
HFCL is not held liable for any damages incurred during the process.
Getting the ion4le Online
Step 1: Power up
The UBR can be powered using a Power over Ethernet (PoE) adapter with a
48-volt output, as indicated below.
Note
To power on the UBR, only use the HFCL PoE adapter. The plug and adapter may
vary by country or region.
Step 2
Connect to the network Follow the steps mentioned below and connect UBR to a
network.
- Connect an Ethernet cable to your laptop/computer.
- Connect the opposite end of the Ethernet cable to the data port on the PoE adapter.
- To power on the device, link the UBR’s Ethernet port, designed for PoE support, to the power port on the PoE adapter
- Open the web browser and enter “UBR IP address” in the address bar. The default static IP address for 2×2 UBR is set to “192.168.1.1”
- A login screen will appear.
- Enter the default login credential details:
- User- admin
- Password- HFcl!@23#ion
- refer to our user manual on our website io.hfcl.com for detailed information to configure UBR
Step 3
Check the LED status
NOTE- During Reboot and Factory Reset, all three LEDs will glow for 7 seconds and the power LED will continue to glow.
Safety Precautions
Observe the following safety precautions to avoid damage to the ion4le UBR
- Do not power the device during installation
- Do not subject the device to high temperatures
- Keep away from high-voltage cables
- Do not power off the unit in the middle of an upgrade process
- The gland should be ground facing all the time
- Make sure the earthing wire is connected properly to the earthing point
- Do not open the enclosure when the UBR is working
- Fasten the device tightly
Contact Us
Email: iosupport@hfcl.com
Website: www.hfcl.com |
www.io.hfcl.com
Address: 8, Commercial Complex, Masjid Moth,
Greater Kailash-II, New Delhi- 110048
HFCL Limited All Rights Reserved. HFCL and io by HFCL are trademarks or registered trademarks of HFCL Ltd. Specifications are subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>