marklin 81771 Train Set Installation Guide
- June 17, 2024
- marklin
Table of Contents
marklin 81771 Train Set
Safety Notes
- This locomotive must not be supplied with power from more than one power pack.
- Operation with conventional DC locomotive controller (max. ±10 volts =). Use only current train controllers on which the maximum voltage is the same as the specification given here.
- Make sure you follow the safety notes in the operating instructions for your train controller.
- The feeder track must be equipped to prevent interference with radio and television reception when the locomotive is to be run in conventional operation. The 8590 interference suppression set is to be used for this purpose.
- Do not expose the model to direct sunlight, extreme changes in temperature, or high humidity.
- WARNING! Sharp edges and points are required for operation.
- The wire used for feeder connections to the track may be a maximum of 2 meters / 78 inches long.
- The LEDs in this item correspond to Laser Class 1 according to Standard EN 60825-1.
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required to guarantee the
operation for which a model is designed. Do not make any changes to the
current-conducting parts.
Note: Several parts are offered unpainted or in another color. Parts that are not listed here can only be repaired by the Märklin repair service department. Details in the image may differ from the model.
INSTALLATION INSTRUCTION
PARTS
- Gebr. Märklin & Cie. GmbH
- Stuttgarter Str. 55 – 57
- 73033 Göppingen
- Germany
- www.maerklin.com
- www.maerklin.com/en/imprint.html
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>