AZIJYV F1 867 Car Electronic Throttle Controller Instructions

AZIJYV F1 867 Car Electronic Throttle Controller

PRODUCT INFORMATION

Specifications

• Model: Car Electronic Throttle Controller
• Function: Controls the throttle response speed and acceleration performance of the car

Installation Instructions
Follow the steps below to install the Car Electronic Throttle Controller:

1. Step 1: Pull away the interface of the accelerator pedal. Refer to Picture 1.
2. Step 2: Connect the throttle controller cable plug with the accelerator pedal interface. Refer to Picture 2.
3. Step 3: Tear the protection paper on the back of the Throttle Controller and stick it on the central console. Refer to Picture 3.
4. Connect the Throttle Controller with the accelerator Pedal interface.
5. Stick the Throttle Controller on the central console.
6. Connect the plug with the Throttle Controller and bind the wire if necessary.

Safety Precautions
Always prioritize driving safety when adjusting the product.

Operation

• This product can be operated using the three keys:
  • Mode: Button for selecting different modes
  • -: Button for decreasing the mode level
  • + : Button for increasing the mode level
• To use the Car Electronic Throttle Controller:
  • Press the Mode button to cycle through the available modes: P1 – Comfortable Mode, P2 – Sports Mode, P3 – Racing Mode, NOR – Normal Mode, EC – Fuel-efficient Mode.
  • Use the – and + buttons to adjust the level of the selected mode. Note that all modes except NOR have 9 levels of adjustment.

Explanation for Different Modes

• P1 Comfortable Mode: Accelerate the throttle response speed, start faster, smooth acceleration. Optional 1-9 grade.
• P2 Sport Mode: Improve instant acceleration, cornering performance, and get the best speed-up effect. Optional 1-9 grade.
• P3 Racing Mode: Achieve superior acceleration performance and simulate a racing field experience. Optional 1-9 grade.
• EC Fuel-efficient Mode: Achieve the best fuel-efficient mode, saving approximately 3-8% fuel.
• NOR Normal Mode: Return to the normal control mode.
• Automatic Mode: Long press the + button for 3 seconds to enter automatic mode. The screen will show “AAA”.
• Manual Mode: Long press the – button for 3 seconds to enter manual mode. The screen will show “SSS”.

Troubleshooting

1. If the engine sound becomes loud and the accelerator pedal does not respond after installation, turn off the car, remove the key, and start again.
2. If the RPM increases and the engine fault light turns on, remove the accelerator and start the car several times. If the fault code persists, it is recommended to use a diagnostic tester for further troubleshooting.
3. If the accelerator cannot stop when the car runs in racing mode P3.1 to P3.9, unplug the Throttle Controller immediately. Racing mode has a very strong effect and may increase fuel consumption and make it difficult to control.
4. If there is engine shake in the 5th gear, check the mode. If using P2.8 sports mode, adjust to P2.1 as the effect may be too strong for the gearbox to respond. If acceleration is not felt under P2.7, it is recommended to use P3.1.
5. If there is a delay when accelerating rapidly or if changing modes during cruise does not change RPM, it may be a transmission reaction problem. Adjust to comfortable mode and avoid sudden acceleration.

FAQ

• How do I adjust the mode level?
  Use the – and + buttons to decrease or increase the mode level respectively.

• Can I use the racing mode for everyday driving?
  It is not recommended to use the racing mode for everyday driving as it has a strong effect, increases fuel consumption, and may be difficult to control.

• How do I enter automatic or manual mode?
  Long press the + button for 3 seconds to enter automatic mode (AAA displayed on the screen) or long press the – button for 3 seconds to enter manual mode (SSS displayed on the screen).

Function And Specification

1. The product can improve the car handling ability by control the sensitivity of car throttle controller switch,and adapt to different driving habit and road conditions.

2. there are 5 Modes as below:

   • P1-Comfortable Mode
   • P2-Sports Mode
   • P3-Racing Mode
   • NOR-Normal Mode
   • EC-Fuel-efficient Mode
     Except the Normal mode, all other modes have 9-level fine-tuning function

3. There are 9 levels ( 1-9) for the acceleration, the acceleration sense from weak to strong is very obvious, and not affect the throttle control capability.
   Please note: The factory default setting mode is P2.6

4. This product is suitable for all car models, gasoline, diesel, hybrid oil and electricity, or pure electricity.

Installation Instruction

1. Connect the Throttle Controller with the accelerator Pedal interface
2. Stick the Throttle Controller on central console
3. Connect the plug with the Throttle Controller,bind the wire if necessary.

• Step1:
  Pull away the interface of the accelerator pedal.Please refer to picture 1

• Step2:
  Connect the throttle controller cable plug with accelerator pedal interface .Please refer to picture 2

• Step3:
  Tear the protection paper on the back of Throttle Controller, and stick it on the central console

Safety Precautions

1. Before the installation, user need to check the Electronic Throttle Controller plug and accelerator pedal interface, they should be connect properly.
2. After finish installation, please start engine under the Neutral Gear or P Gear,and check the accelerator pedal is work.
3. If install the wrong direction, it will cause the accelerator pedal invalid and the warning light of engine will be on. If in this situation, please don’t worry, this products has the internal protection circuit, which will prevent harms to the vehicle parts. Please turn off the engine and disassemble this product.After 2 minutes, install this product in the correct way,then it can work.

Operation

• This product can be operated by the three keys ,from left to right, the buttons are ‘Mode’, ‘－’, ‘＋’
• The product can be adjusted at any time after power on, but please pay attention to driving safety when adjusting the product.
• Press the mode button , it will show: P1-Comfortable Mode,P2-Sports Mode, P3-Racing Mode,NOR-Normal Mode,EC-Fuel-efficient Mode
•  the two button can adjust the level of the mode from weak to strong, there are 9 levels (1-9),Please note: except the Nor-Original Mode,all of above modes have 9 levels adjustment function.

Explanation for different mode

• P1 Comfortable Mode
  Accelerate the throttle response speed, start faster, smooth acceleration, optional 1-9 grade. (P1.9 means comfortable mode and 9 level)

• P2 Sport mode
  Improve instant acceleration, improve cornering performance, and get the best speed-up effect. 1-9 level to adjust from weak to strong (P2.9 means Sport Mode and 9 level)

• P3 Racing Mode
  Achieve the Superior acceleration performance and make it feels like in the Racing-Field. 1-9 level to adjust from weak to strong. (P3.9 means Sport Mode and 9 level)

• EC Fuel-efficient Mode
  Achieve the best Fuel-efficient mode, about 3-8% fuel saving.

• NOR Normal Mode
  Back to the Normal control mode.

• Automatic Mode
  Long press”+” for 3 seconds,screen will show AAA,it means enter into automatic mode

• Manual Mode
  Long press “－” for 3 seconds,screen will show SSS,it means enter into manual mode

Troubleshooting

1. After the device is properly installed, the engine sound becomes loud and the accelerator pedal does not respond.
   Turn off the car, remove the key, and start again

2. The power is not obvious or does not respond after normal installation
   Device self-learning steps:

3. Connect the line when the car is powered off, and then power on the car but do not start it.

4. Long press the MODE button to enter the setting 8xx mode, and then adjust to 800 by the ‘-’ or ‘+’ button.

5. After the screen shows 800, then press the accelerator to the bottom and then release it

6. Long press the MODE button for more than 5 seconds. After the screen jumps out of the 800 mode, the learning is successful.

7. RPM increased than before, engine fault light also turned on
   Remove the accelerator, then start the car seven or eight times. If the fault code has not been removed, it is recommended to use a diagnostic tester to eliminate it.

8. The accelerator cannot stop when the car runs at racing mode P3.1 to P3.9, and the accelerator pedal cannot be stopped.
   The racing mode has a very strong effect. We recommend not to use the racing mode, cause its effect is very strong, it also will increase the fuel consumption,and very hard to control.You must unplug it if out of control.

9. The feeling of engine shake in the 5th gearbox
   Check the mode first, if using P2.8 sports mode. You can adjust to P2.1, the effect is too strong and the gearbox cannot respond. (If you don’t feel the acceleration under P2.7, it is recommended to use P3.1)

10. After tried all modes, there will be a delay when the vehicle is accelerating rapidly, and if you change the mode during cruise, the RPM will not change.
    When accelerating quickly, the gearbox didn’t respond, so it has been stuck there without shifting; this is the car’s transmission reaction problem. Please adjust to comfortable mode, don’t speed up suddenly.

11. The competitive mode is similar to the original car mode
    Check the mode is wrong or not; remove it for a few days and re-install it. If the change is slow, you may get a fuel-saving mode. To avoid adjust wrong mode, it is recommended to read the letters on the manual and re-adjust

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>