Schlage XE360 VD99 RX Wiring Kit Instruction Manual
- June 17, 2024
- Schlage
Table of Contents
Schlage XE360 VD99 RX Wiring Kit
Product Information
Product Name: XE360 Von Duprin 99 Exit RX
Wiring Kit
Model Number: 115867
Manufacturer: Von Duprin
Specifications
- Material: White Paper
- Dimensions: 8.500″ (width) x 11.000″ (height)
- Revision: A
- Created By: M. Sasso
Product Usage Instructions
Route RX wires
-
Route wires through channel beneath baseplate:
As shown in the diagram, route the RX wires through the channel located beneath the baseplate of the exit device. -
Trim and route wires up into center case area:
If necessary, trim the exit device RX wires to the desired length. Then, route the trimmed wires up into the center case area.
Connect wires and mount the device
-
Route the harness around the side of the center case:
Take the harness and route it around the side of the center case of the exit device. -
Connect to the REX harness:
Connect the RX harness to the REX harness of the exit device -
Make connections with provided Scotchlok connectors inside the center case:
Inside the center case, use the provided Scotchlok connectors to make the necessary wire connections. The color orientation of the connectors does not matter. -
Finish mounting the exit device:
-
Complete the installation by finishing the mounting of the exit device according to the manufacturer’s instructions.
Additional Notes
Revision History
A, B, C, D, E, F (latest revision)
Title: SHEET, INSTRUCTIONS, XE360 RX WIRING KIT
Creation Date: 06-08-23
Software: InDesign CS6
Scan for user guide, interactive instructions, warranty and more! alle.co/XE360
FAQ
Q: Where can I find the user guide, interactive instructions, and warranty information?
A: You can scan the provided QR code or visit alle.co/XE360 for access to the user guide, interactive instructions, and warranty information.