PUREGEAR 10644PG 5.000mAh Magnetic Wireless Portable Charger Instruction Manual
- June 17, 2024
- PURegeaR
Table of Contents
10644PG 5.000mAh Magnetic Wireless Portable Charger
5,000mAh
MAGNETIC WIRELESS
PORTABLE CHARGER
Specs
- USB-C™ Input: 5V/2A
- USB-A Output: 5V/2.1A
- Magnetic Wireless Output: 5W
- Total Output: 10W (Max)*
Provides up to 2 charges
Caution
DO NOT place any credit cards or other types of magnetic material near the
charging pad. Do not attempt to disassemble the wireless charging pad as it
may short circuit or damage the product. Keep at least 8” (20cm) distance
between implantable medical devices such as pacemakers, cochlear implants,
etc. Keep this product in a dry and ventilated space. Do not place in direct
heat or use in high humidity environments. Do not use organic solvents to
clean surface.
Instructions
Charging your 5K Magnetic Wireless Portable Charger using a wall charger, car charger, or computer:
- Use the provided USB-C to USB-A cable and insert the USB-C connector into the USB-C port on the charger.
- Plug the USB-A into your existing wall charger, car charger or computer. The status indicator lights will flash to show charging has begun. When the charger is fully charged, the lights will stop flashing.
NOTE: Charging times vary based on the charging method and output power.
Charging Indicator Light Status:
- 4 lights = full battery
- 3 lights = 3/4 battery remaining
- 2 lights = 1/2 battery remaining
- 1 light = 1/4 battery remaining
Charging your device via cable:
- Using the appropriate USB-A charging cable for your device, insert the USB-A connector into the USB-A port of the charger and connect to your device via the corresponding connector. Charging will automatically begin.
To charge your device wirelessly:
- Place the 5K Magnetic Wireless Portable Charger onto the back of your MagSafe® device until it automatically aligns and snaps into place.*
- Push the power button to begin charging.
*Works with MagSafe cases. Non-MagSafe cases must be removed before charging.
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy; if not installed and used in accordance
with the instructions, maybe cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposur e requirement. The device can be used in portable exposure condition without restriction.
Limited Lifetime Warranty
This product is fully warranted against defects in materials and workmanship
for the lifetime of the product, so long as the manufacturer continues to make
this product. If a product fails due to a manufacturing defect, we will
replace it upon proper proof of purchase by the original purchaser.
Replacement product will be subject to shipping and handling charges. Damages
through normal wear and tear, alteration, misuse, neglect, accident, service
by anyone other than the authorized service center, or act of God, are not
covered by this warranty. For all warranty claims, the product must be
returned in accordance with PureGear’s return policy.
USB-C is a trademark of USB Implementers Forum.
All trademarks and trade names are used for reference purposes only and are
the property of their respective owners.
www.pure-gear.com
©2024 F00209PG
Documents / Resources
|
PUREGEAR 10644PG 5.000mAh Magnetic Wireless Portable
Charger
[pdf] Instruction Manual
YJW-10644PG, YJW10644PG, 10644PG, 10644PG 5.000mAh Magnetic Wireless Portable
Charger, 5.000mAh Magnetic Wireless Portable Charger, Magnetic Wireless
Portable Charger, Wireless Portable Charger, Portable Charger, Charger
---|---