PureGear 10652PG 15W Fast Wireless Charging Pad Instructions
- June 15, 2024
- PURegeaR
Table of Contents
15W FAST WIRELESS
CHARGING PAD
Specs
Wireless Charging Pad:
-
Input: 5VDC/2A; 9VDC/1.67A; 12VDC/1.5A
-
Output: Up to 15W (Fast Charge)**
-
Charging time may vary based on device.
NOTE:** 20W USB-C Power Adapter is required (not included) to enable fast wireless charging.
CAUTION:
DO NOT place any credit cards or other types of magnetic material near the
charging pad. This product can ONLY be charged using the provided adapters and
cables. Do not attempt to disassemble the wireless charging pad as it may
short circuit or damage the product. Keep this product in a dry and ventilated
space. Do not place in direct heat or use in high humidity environments. Do
not use organic solvents to clean surface.
Using your Fast Wireless Charging Pad
- Connect the USB-C cable to the USB-C port on your Fast Wireless Charging Pad.
- Plug the USB-C connector into the wall charger. (USB-C wall charger not included.)
- Plug in the wall charger.
- Place your Qi-enabled device on the Fast Wireless Charging Pad with the screen facing up. The LED is white when your device is charging.
Charging Indicator Light Status:
ORANGE LIGHT: Device is not charging properly. Please reposition your
device until you see the white light come on.
WHITE LIGHT : Device is charging.
Lifetime Warranty
This product is fully warranted against defects in materials and workmanship
for the lifetime of the product, so long as the manufacturer continues to make
this product. If a product fails due to a manufacturing defect, we will
replace it upon proper proof of purchase by the original purchaser.
Replacement product will be subject to shipping and handling charges. Damages
through normal wear and tear, alteration, misuse, neglect, accident, service
by anyone other than the authorized service center, or act of God, are not
covered by this warranty. For all warranty claims, the product must be
returned in accordance with PureGear’s return policy.
USB-C is a trademark of USB Implementers Forum.
The ‘Qi’ symbol is a trademark of the Wireless Power Consortium.
All trademarks and trade names are used for reference purposes only and are
the property of their respective owners.
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
FCC Interference Statement (cont.)
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, maybe cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.