Dolphin X25 Robotic Pool Cleaner User Guide

Dolphin X25 Robotic Pool Cleaner

Thank you

Thank you for purchasing a Maytronics Robotic Pool Cleaner.
The Robotic Pool Cleaners by Maytronics deliver advanced cleaning technology, long-lasting performance and easy maintenance. You and your family will be free to enjoy swimming with full confidence that your pool is completely clean.

Precautions

Cautions & Warnings

• Use the originally supplied power supply only.
• Do not use an extension cable in any case whatsoever.
• Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter.
• Keep the power supply out of standing water.
• Take the Robot Pool Cleaner out of the pool before allowing people to enter the pool.
• Unplug the power supply before servicing.
• Do not pull the Pool cleaner from the pool using the cable.
• Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 ppm; pH 7.0 – 7.8; Temperature 6 -34°C (43-93°F); NaCl Maximum = 5000 ppm.
• Specifications:
  • Motor protection: IP 68
  • Minimum depth: 0.80m/2.6ft
  • Maximum depth: 5m/16.4ft

Helpful hints

• When working, the Power Supply should be placed in the shade.
• If the Dolphin is fitted with combined or wonder brushes, gently aqueeze the brushes until they are soaked with water.
• Release minimal required floating cable length to ensure proper pool coverage. Leave excess cable rolled outside the pool.
• After each cleaning cycle wash the filter bag or cartridge. Clogged filter bags reduce scanning and cleaning efficiency.
• Once a week unplug the cable from the power supply, unwind the tangled portions of the cable, straighten it out and leave it in the sun for several houres.
• Store the pool cleaner in a shady place on its Caddy, if not on a caddy, place the pool cleaner upside down.

Robot operation

Set-Up

1. Attach the floating cable to the power supply.
2. Position the power supply at least 3m/10ft away from the edge of the pool.

Into the pool

• Put the Pool Cleaner into the pool.
• Release the Pool Cleaner and let it sink to the floor of the pool.
• Make sure that the floating cable is free of any obstructions.

Operation

• Turn the power supply ON.
• The Pool Cleaner will now operate until it has reached the end of the cleaning cycle.

Out of the pool

Cleaning the filter

• It is highly recommended to clean the filter basket after each cleaning cycle.

Note: Don’t let the filter cartridges dry out before cleaning.

Warning: Unplug the power supply before servicing

• Open the filter cover.
• Lift up the basket.
• Open the latch to release the bottom lid in order to remove the debris.
• Clean the filter basket with a hose.

Storage

• Coil the cable and store in a cool, dry place on the Caddy.
• Do NOT store the robot where it will be exposed to direct sunlight, excessive heat or to frost.

Maintenance

Periodic filter cleaning

Dismantle the 4 ultra-fine filter panels of the outer basket according to the following steps:

1. Dismantle the panels, starting with pressing on panel no. 1 using your thumbs.
2. Continue to dismantle the panels in the order of their numbers: no.2–> no.3–> no. 4.

Cleaning the impeller

If you notice debris trapped in the impeller:

• Unplug the power supply before servicing

Clean the debris trapped in the impeller opening, according to the following steps:

For a detailed manual (including videos): manuals.maytronics.com/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>