HELVIA GALA-520DW 5.25 Inch Dual Cone Ceiling Speaker User Manual

HELVIA GALA-520DW 5.25 Inch Dual Cone Ceiling Speaker User Manual

IMPORTANT SAFETY INSTRUCTIONS

• Read these instructions
• Keep these instructions
• Heed all warning
• Follow all instructions

Water and Moisture

The apparatus should be protected from moisture and rain and can not be

usednear water; for example near a bathtub, a kitchen sink, a swimming pool, etc.

Heat

The apparatus should be located away from heat sources such as radiators, stovesor other appliances that produce heat.

Object and Liquid Entry

Objects do not fall into and liquids are not spilled into the inside of the apparatus for safety.

Cleaning

Clean only with a dry cloth. Do not use any solvents such as benzene or alcohol.

Servicing

Do not implement any servicing other than those means described in the manual. Refer all servicing to qualified service personnel only. Only use accessories/attach- ments or parts recommended by the manufacturer.
Thank you for purchasing your GALA-520DW ceiling speakers. All units have been rigorously tested before leaving the factory. Carefully unpack the carton and check the contents to ensure that all parts are present and in good conditions:

• 1x GALA-520DW ceiling speaker
• 1x Quick Guide

If anything damaged during transport, notify the shipper immediately and keep packing material for inspection. Again, please save its carton and all packing materials. If the unit must be returned to the manufacturer, it is important that
the unit is returned in the original manufacturer’s packing. Please do not take anyaction without first contacting us.
Our products are subject to a continuous process of further development. There- fore modifications to the technical features remain subject to change without further notice.
GALA-520DW offers elegant, reliable and versatile loudspeakers with dual-cone woofer diameter of 5.25”, and powers from of 10W/20W at 100V. It can be used with standard 70/100V professional amplifiers, and is suitable for any application of music distribution in shops, restaurants, bars, offices, shopping malls, schools, etc.
GALA-520DW ceiling speaker feature high quality ABS frame, aluminum grille, and quick-fit mechanism, to make installation very easy and fast. The built-in line transformers allow the use with 70/100V lines, and offer two power taps (10W, 20W) to better adapt to different speaker arrangement and amplifier powers.

They come in white color, but can be painted in any color.

• Dual-Cone Loudspeaker
• 25” Woofer Diameter
• 20W RMS Power
• Built-in 70V/100V Line Transformer
• 10W-20W @100V Power Taps
• Quick Mounting System
• Paintable Grille and Frame

GALA-520DW Sizes

Read these instructions carefully before installing and using the

product.

1. When the speaker is installed on ceilings, check that the structure is reliabl and the speaker is firmly attached.
2. Do not use nails, adhesives or other unauthorized devices. Long-term use and vibrations may cause it to fall
3. Do not place the speakers on a turntable or movable
4. Do not touch or bump the If these are damaged, the sound will be distorted.
5. Do not listen to sound at a very high level when you are changing the input source (for example, from FM Tuner to CD player). Please be sure the power amplifier is turned off or master volume is at lower
6. Do not attempt to clean the speakers with chemical solvents as this may damage the paint Clean with a dry cloth.

Speaker Installation

The installer is responsible of installation. Please pay attention to install speakers according to local safety regulations.
When handling the loudspeakers, be careful not to touch the front of the net, otherwise there is a risk of deforming it.

• Step1: Draw a ceiling hole on the ceiling with a diameter corresponding to the ones shown on “4. PRODUCT APPEARANCE” at page 6.

• Step2: Use appropriate tools to open the mounting hole on the

• Step3: Remove the speaker grille by using the special tool (supplied).

• Step4: Connect the speaker cable to the electric terminals (check “5.2. Speaker Connection” at page 8).

• Step5: Insert the speaker into the Rotate the mounting screw clockwise

• Step6: Install the speaker

Speaker Connection

GALA-520DW speakers are equipped with a built-in line transformer with 2 power taps, to better adapt each speaker to the type of line (constant voltage @ 70V or 100V), the power of the amplifier, and the number of speakers in the system.

When connect the speaker to the 70/100V line, pay attention to wire colors. Please refer to the following table when connect them to the line.

• Connect Black wires to Ground terminal (-) of the 70/100V Connect White Wire (full power) or Red Wire (half power) on (+) terminal of the 70/100V amplifier according to the number of speakers used, and the amplifier power.
• In case of parallel speaker connection, please make sure that there is not in- verted polarity (+ connected to -). If the polarity of the speakers is reversed, the sound will be unnatural and will play without

UNDER-POWERING VS OVER-POWERING

Most speaker damages are caused by amplifiers with too little power (wattage). Overdriven amplifiers clip output waveforms and send distortion to the speakers. Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear sound.
If you hear this condition at loud volume levels, turn down the amplifier volume until the distortion is no longer present. Damages caused by operating the speak- ers at distorted volume levels are no covered by warranty.

Example of 70V/100V System Configuration

NOTE: Total number of speakers multiplied by tap value cannot exceed the output power (in watts) of the 70V/100V amplifier. The above examples shows 5 total speakers in a 100V system. If you use 20W tap position, you need an amplifier with at least 5×20=100W. A good rule of thumb is to use an amplifier with 20% greater power; in this case, an amplifier with 120W or more.

TECHNICAL PARAMETERS

.Frequency Response Chart

NOTE: The Frequency chart below shows dB SPL (1W @ 1m).

GALA-520DW

Specifications

Our products are subject to change. Modifications to technical features remain subject to change without notice

WARRANTY AND SERVICE

All HELVIA® products are covered by warranty according to European regulations (2 years in the case of purchase by private person – B2C; 1 year in the case of purchase by company

– B2B). The warranty is valid from the date of purchase by the end user (private individual or company), indicated in the purchase document (receipt in the case of private person; invoice in the case of company). The following cases / components are not covered by the above warranty:

• All accessories supplied with the product;
• Improper use;
• Failure due to wear and tear;
• Any unauthorized modification of the product by the user or third

HELVIA must meet the warranty obligations due to any non-compliant materials or manu- facturing defects, by remedying free of charge at HELVIA’s discretion by either repairing or replacing specific parts or the entire equipment. Any defective parts removed by a product in the event of a warranty claim become property of HELVIA.

During the warranty period, defective products can be returned to HELVIA retailer or installer with proof of original purchase (receipt or invoice). To avoid damage during trans- port, please use the original packaging, if available. For more information, visit the website: www.frenexport.com.

WARNING

READ CAREFULLY – only for EU and EEA (Norway, Iceland and

Liechtenstein).

This symbol indicates that the product must not be disposed of with household waste, according to the WEEE directive (2202/96/EC and subsequent amendments) and national legislation.
The product must be delivered to a designated waste collection center (e.g. on an autho- rized one-for-one basis when you buy a new similar product, or to an authorized collection site for recycling waste electrical and electronic equipment).
Improper handling of this type of waste can have a negative impact on the environment
and human health due to potentially dangerous substances that are generally associated with electrical and electronic equipment. At the same time, your cooperation in the proper disposal of this product will contribute to the effective use of natural resources.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, approved WEEE scheme or your household waste disposal service.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>