HELVIA STONE 640XGR Environmental Speaker User Manual

June 13, 2024
HELVIA

STONE 640XGR Environmental Speaker

HELVIA STONE 640XGR Environmental Speaker - System
Configuration User Manual

STONE-640X
IP56 Rock Coaxial Speaker with 6.5” Woofer and 0.5” Tweeter
Please read this manual carefully and keep it for future reference

Dear value Customer,
First, thank you for purchasing a HELVIA® product. Our mission is to offer solutions based on the most up-to-date technologies for all systems integration needs in the private, commercial and corporate sectors.
We hope you are satisfied with this product and, if you wish to participate, we would be very pleased to receive your feedback on the operation of this product and possible improvements for the future. You can go to “CONTACT” section of www.frenexport.com and send an e-mail with your opinion; this would help us make equipment that are closer to the real needs of our customers.
Finally, please read this user manual carefully before using the product; incorrect use could cause damages to you and the product. Take care! The HELVIA team

IMPORTANT SAFETY INSTRUCTIONS

  • Read these instructions
  • Keep these instructions
  • Heed all warning
  • Follow all instructions

Object and Liquid Entry
Objects should not fall and liquids should not be spilled into the inside of the apparatus for safety.
Cleaning
Clean only with a dry cloth. Do not use any solvents such as benzene or alcohol  as they may damage the surface.
Servicing
Do not implement any servicing other than those means described in the manual.
Refer all servicing to qualified service personnel only. Only use accessories/attachments or parts recommended by the manufacturer.

UNPACKING

Thank you for purchasing your STONE-640X IP56 Rock Coaxial Speaker. All units have been rigorously tested before leaving the factory. Carefully unpack the carton and check the contents to ensure that all parts are present and in good conditions:

  • 1x Coaxial speaker STONE-640X
  • This User manual

If anything is damaged during transport, notify the shipper immediately and keep packing material for inspection. Again, please save its carton and all packing materials. If the unit must be returned to the manufacturer, it is important that the unit is returned in the original manufacturer’s packing. Please do not take any action without first contacting us. Our products are subject to a continuous process of further development.
Therefore modifications to the technical features remain subject to change without further notice.

PRODUCT OVERVIEW

Increasingly, sound systems for outdoor installations are demanding higher levels of sound quality and higher sound pressure levels. Whether in gardens, parks, patios or other outdoor locations, these speakers are designed to deliver high quality sound and blend in with the surroundings.
HELVIA’s STONE-640X loudspeaker is designed for gardens, terraces, outdoor restaurants, parks, and generally any outdoor or indoor location where the loudspeaker base can be buried and a look that blends in with the landscape is required.
The 40W RMS coaxial speaker is equipped with a 6.5” woofer and a 0.5” Mylar dome tweeter to provide a good frequency response and excellent sensitivity.
The waterproof fiberglass construction of the STONE-640X is designed for durability in all weather conditions. The IP56 rating prevents direct exposure to water and mud, greatly extending the life of the speaker. The rock-like grey finish allows maximum camouflage of the speaker in natural landscapes such as gardens, parks, etc.
The connection cable offers 6 power levels plus 8 ohms to adapt the speaker to different line types (70V, 100V, 8Ω) and power levels.
3.1. Main Features:

  • IP56 Protection for Outdoor use
  • Fiberglass housing for all-weather exposure
  • Rock design to blend in with the surroundings such as gardens and parks
  • 40W RMS (160W peak)
  • Line transformer for 70V, 100V and 8 ohms operation
  • 6.5” Coaxial Speaker with 0.5” Mylar dome tweeter

PRODUCT APPEARANCE

4.1. Front PanelHELVIA STONE 640XGR Environmental Speaker - Front
Panel

INSTALLATION

Read these instructions carefully before installing and using the product:

  1. When the speaker is installed in any outdoor location, make sure that the structure on which it is installed is reliable and that the speaker is firmly attached.
  2. Do not place the speaker on a movable or unstable support.
  3. Use only approved and certified wiring in your installation. Do not stretch or place the wire in contact with sharp objects.
  4. Before removing the cables, make sure the amplifier and other components are switched off.
  5. Damage to the woofer and tweeter may occur if the speaker is bumped or hit, resulting in distorted sound or no sound at all.
  6. Never overdrive your speaker to the point of distortion and always reduce volume prior to switching input sources.

The installer is responsible for the installation. Please make sure to install speakers according to local safety regulations.

5.1. Direct Burial Wire or Conduit
Depending on the type of installation, direct burial of the speaker wires from the amplifier to the speakers may be required. Use of ID 12 conduit pipe may be adequate for protecting the wires from possible physical damage if future excavation or other alterations are expected in the area of the installation.
5.2. Speaker Connection/Wiring.
STONE 640X speakers are equipped with a built-in line transformer for 70V, 100V and 8 ohm operation, to better adapt each speaker to the type of line, the power of the amplifier, and the number of speakers in the system.
Pay attention to wire colors depending on which line type you use. Please refer to the instructions below, or to the sticker on the bottom of the speaker or on the speaker wire:HELVIA STONE 640XGR Environmental Speaker -
Speaker Connection

  • For 8 ohm operation, join the Red and White wire and connect them to the (+) terminal of the amplifier. Connect the Black wire to the (-) terminal (COM) of the amplifier.
  • For 100V and 70V operation, join the Red and White wire and connect them to the (-) terminal (COM) of the amplifier. Connect the colored wires to the (+) terminal of the amplifier according to the line, number of speakers used and amplifier power.
  • Please make sure the polarity is not inverted (+ connected to -). If the polarity of the speakers is reversed, the sound will be unnatural and will play without bass.

Solder wires together using waterproof heat shrink tubing to seal.
Use waterproof wire connectors.
Make connections with immersion-resistant crimp splices.

UNDER-POWERING VS. OVER-POWERING

Most speaker damage is caused by amplifiers with too little power (wattage).
Overdriven amplifiers clip output waveforms and send distortion to the speakers.
Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear sound.
If you hear this condition at loud volume levels, turn down the amplifier volume until the distortion is no longer present. Damages caused by the operating the speakers at distorted volume levels are not covered by the warranty.
6.1. Example of 70V/100V System ConfigurationHELVIA STONE 640XGR
Environmental Speaker - System Configuration 5 speakers connected in parallel using 16W taps
The total number of speakers multiplied by the tap value cannot exceed the output power (in watts) of the 70V/100V amplifier.The above example shows 5 total speakers in a 70V/100V system. Using the 16W taps, you will need an amplifier with at least 5×16= 80W. A good rule of thumb is to select an amplifier with 20% greater power; in this case, an amplifier that delivers about 100W.

TECHNICAL PARAMETERS

7.1. Specifications

Model STONE-640X
Speaker Type 2-Way Passive Coaxial
Impedance
Frequency Response 75Hz-20kHz
RMS Power 40W
Sensitivity 87dB (1W @1m)
Power Taps @ 100V 32W-16W-8W-4W & 8Ω
Power Taps @ 70V 32W-16W-8W-4W-2W & 8Ω
Woofer Type 6.5” Polypropylene cone with rubber edge
Tweeter Type 0.5” Mylar Dome Tweeter
Coverage (HxV) 100° x 100°
Crossover 1st-order, 6dB/Octave
Connection Raw Cable
Cabinet Material Waterproof Fiberglass
Grid Aluminum
Cabinet Color Grey
IP Rating IP56
Product Size (WxDxH) 340 x 255 x 265 mm (13.4 x 10 x 10.4 in)
Product Net Weight 4,5 kg (9.9 lbs.)
Packing Size (WxDxH) 400 x 320 x 285 mm (15.7 x 12.6 x 11.2 in)
Packing Weight 5,4 kg (11.9 lbs.)

Our products are subject to change.Modifications to technical features remain subject to change without notice.

WARRANTY AND SERVICE

All HELVIA® products are covered by warranty according to European regulations (2 years in the case of purchase by private person – B2C; 1 year in the case of purchase by company – B2B). The warranty is valid from the date of purchase by the end user (private individual or company), indicated in the purchase document (receipt in the case of private person; invoice in the case of company). The following cases / components are not covered by the above warranty:

  • All accessories supplied with the product;
  • Improper use;
  • Failure due to wear and tear;
  • Any unauthorized modification of the product by the user or third parties.

HELVIA must meet the warranty obligations due to any non-compliant materials or manufacturing defects, by remedying free of charge at HELVIA’s discretion by either repairing or replacing specific parts or the entire equipment. Any defective parts removed by a product in the event of a warranty claim become property of HELVIA.
During the warranty period, defective products can be returned to HELVIA retailer or installer with proof of original purchase (receipt or invoice).
To avoid damage during transport, please use the original packaging, if available. For more information, visit the website: www.frenexport.com.

WARNING

READ CAREFULLY – only for EU and EEA (Norway, Iceland and Liechtenstein).
This symbol indicates that the product must not be disposed of with household waste, according to the WEEE directive (2202/96/EC and subsequent amendments) and national legislation.
The product must be delivered to a designated waste collection center (e.g. on an authorized one-for-one basis when you buy a new similar product, or to an authorized collection site for recycling waste electrical and electronic equipment).
Improper handling of this type of waste can have a negative impact on the environment and human health due to potentially dangerous substances that are generally associated with electrical and electronic equipment. At the same time, your cooperation in the proper disposal of this product will contribute to the effective use of natural resources. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, approved WEEE scheme or your
household waste disposal service.

Set up your solution
www.frenexport.com
This product is imported in the European Union by
FRENEXPORT SPA – Via Enzo Ferrari, 10 – 62017 Porto Recanati – Italy
HELVIA® is a registered trademark of FRENEXPORT SPA – Italy
Ver 1.0 – Jul. 2023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HELVIA User Manuals

Related Manuals