ZUMTOBEL P INF WW LDO TL R200 Evolution R LED Downlight Instruction Manual
- June 16, 2024
- ZUMTOBEL
Table of Contents
www.Zumtobel.com
Mounting instructions
P INF WW LDO TL R200 Evolution R LED Downlight
P -INF R200WW LDO TL
TYP
E13442 E13443
E14795 E14796
Important notices. Please, read first!
-
The installation and commissioning of the luminaire as well as any modification to the luminaire may only be performed by authorized personnel (qualified electrician).
The manufacturer is not liable for damages resulting from improper or faulty installation or operation or from unauthorized modifications to the luminaire.
The luminaire is used exclusively for lighting and is to be installed in accordance with the .
national installation regulations -
Use of the supplied control gear only in conjunction with the associated luminaire Caution, risk of electric shock! Disconnect mains cables and any existing DALI control lines from mains and check that the power is off before conducting any maintenance and assembly work.
Hot plug-in is not permitted. Hot plug-in may result in damage to the luminaire and entail loss of warranty claims!
Neutral conductor breaks during operation will result in power surge damage to the lighting system. Therefore neutral disconnect terminals in three-phase AC circuits may only be opened voltage-free and must be closed before power supply is switched back on. -
Luminaire not suitable for covering with material.
-
thermally insulating The luminaire is protection type 44 IP, only when being installed in an enclosed ceiling! Protection type 44 IP 5 does not apply in the ceiling void itself.
With it it is recommended that ceiling reinforcing rings or frames should be used to enlarge the thin or soft ceiling material bearing surface. -
Commissioning after the construction phase, if the mains voltage is continuously present!
Dispose of packaging and luminaire in accordance with applicable regional regulations. -
Keep the instructions safe!
Specifications are subject to change without notice! If you have questions, please contact the manufacturer.
Dismantling
Reflector cleaning
Reflector cleaning cloth
The servicing of the control gear in this luminaire should only be undertaken by the manufacturer or his service agent or a similar qualified person. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Zumtobel
Info on (non-) replaceability
ZUMTOBEL Postfach 760 D-32637 Lemgo
* Tel. + 49/(0)5261/212-0*
Fax +49/(0)5261/212-9000**
* Internet: http://www.Zumtobel.com