ZUMTOBEL CL2 S SG LED Ceiling Light Installation Guide
- June 15, 2024
- ZUMTOBEL
Table of Contents
- ZUMTOBEL CL2 S SG LED Ceiling Light
- BC (Bluetooth® CASAMBI)
- Mounting instructions
- OPTION: Emergency Lighting (self-contained)
- OPTIONS for DIP-Switches (MWCF)
- OPTION MWCF {TRIDONIC 28004371)
- Corridor Function (MWCF)
- Instructions for installation and operation!
- Info on (non-) replaceability
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ZUMTOBEL CL2 S SG LED Ceiling Light
CLEAN II
Supreme recessed
BC (Bluetooth® CASAMBI)
- MP (wide beam)
- MPA (asymmetric beam)
- MWCF (microwave presence sensor+ Corridor Function)
- SW, TW, GBW, RGBW
- IP54
- Emergency (self-contained and centrally supplied)
Mounting instructions
Important notices. Please, read first! Keep the instructions safe! Specifications are subject to change without notice! If you have questions, please contact the manufacturer.
OPTION: Emergency Lighting (self-contained)
OPTIONS for DIP-Switches (MWCF)
OPTION MWCF {TRIDONIC 28004371)
Trouble Shooting Guide
(Problem=> possible Reasons=> Actions)
Fitting does not switch off
- Continuous movements within detection area => Check area
- Fitting is vibrating => Check surface and mounting
Fitting switches on without clear movements
- Fitting is vibrating => Check surface and mounting
- Non visible movements (behind a wall) => Check area
Fitting does not switch on despite clear movements
- Detection area is too small => Check mounting instructions
- Sensitivity is set loo low => Extend sensitivity on sensor
Fitting does not dim down (in Corridor Function)
=> Corridor function is not activated => Check mounting instructions
Corridor Function (MWCF)
Instructions for installation and operation!
-
The installation and commissioning of the luminaire as well as any modification to the luminaire may only be performed by authorized personnel (qualified electrician). National installation regulations must be observed. Before any work on the appliance is done, it must be disconnected from mains. Hot plug-in is not an option and may cause damage to the lamp or luminaire! The manufacturer is not liable for damages resulting from improper or faulty installation or operation or from unauthorized modifications to the luminaire. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
Caution, risk of electric shock! -
Specifications are subject to change without notice! If you have questions, please contact the manufacturer.
Info on (non-) replaceability
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>