ENKIN PDD200 Dummy Dimmer Instruction Manual

June 16, 2024
ENKIN

ENKIN Logo PDD200
Dummy Dimmer ENKIN PDD200 Dummy Dimmer

ON & OFF FUNCTION

Dummy dimmer switch is activated by pressing the dimmer shaft.

  • Input voltage: 240V ~ 50Hz
  • Max load: 1000W
Operating Voltage 240V ac
Nominal Operating Frequency 50 Hz
Dimming Technique N/A
Compliance BS EN 60669-2-1
Load Symbol Compatible Loads
--- ---
LED lighting 1000W
240V Incandescent & Halogen lamps 1000W
Low voltage lighting with electronic transformers 1000W

WIRING DIAGRAM – ONE WAY

ENKIN PDD200 Dummy Dimmer -ONE WAY

WIRING DIAGRAM – TWO WAY

ENKIN PDD200 Dummy Dimmer -ONE WAY 1

WARNING
RISK OF ELECTRIC SHOCK

  • Hazardous voltage and electrical current may be present at the wire leads of this product even when the device is switched off.
  • Lock out and tag the input circuit before accessing the wiring connections.
  • This device must be installed by a qualified and experienced electrician in accordance with applicable current electrical regulation.
  • To comply with all safety standards, the product must be used only for the purpose described in this instruction and must be installed in accordance with the wiring rules and regulation in the location where it is installed.
  • There are no user serviceable parts inside the product. Failure to follow these instructions can result in death or serious injury.

EQUIPMENT DAMAGE HAZARD

  • Install the device according to instructions in this document.
  • Pay attention to the specifications and wiring diagrams related to the installation.
  • Do not use this product for any other purpose than specified in this instruction.
  • The product is suitable for indoor use only.
  • Apply IEC60898-1 compliant 250V~ 6A MCB as an overload protective device.

ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

LEGAL DISCLAIMER

The installation of electrical products is inherently dangerous and can lead to serious injury or death. The products we sell MUST be installed by a qualified and experienced electrician in accordance with applicable current electrical regulation. Any advice, guidance or other information provided by Enkin on their website or within any of our publications cannot completely anticipate your situation and common sense must prevail. Products need to be checked prior to installation and regularly for damage and wear and tear. Products should be returned and not used if in any doubt of their integrity.
Electrical rated loads and limits of a given product should NEVER be exceeded at any time. The electricity supply should always be isolated at its source (Distribution Board) before attempting any installation or maintenance.
No advice or information, whether oral or written, obtained by you from us or through the service, our employees, consultants and/or retailers shall create any warranty not expressly made herein.
You agree to assume all and any risk resulting from the utilisation of information provided by Enkin. You also expressly agree not to hold us responsible for any damage, personal injury, death or loss resulting from your use of our information, service or regulatory compliant products. Scan QR Code for more detailed technical information on this product

https://www.enkin.com/LED-Push-Dummy-Dimmer-Module-PDD200
ENKIN PDD200 Dummy Dimmer - lamps 2www.enkin.com

Enkin is a trading name of Trade Ivy.
Registered in England Number: 10809945. Copyright © 2021
All Rights Reserved
Trade Ivy Limited, Unit 3C Latham Park, St Blazey Road, Par, PL24 2HY

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals