BRAEMERE SlurryKat 3500G Dual Doda Umbilical Pump Instruction Manual

Table of Contents

Product Name: 1:32 SlurryKat 3500G Dual Doda Umbilical Pump

Product Type: Tandem Axle Tanker–Doda Kit

To ensure proper painting, it is important to clean all resin parts in warm soapy water. The silicone release agent used in the casting process will react with paint, so it must be thoroughly cleaned off before painting.

Assembly Instructions

Step One

Glue the fins to either side of the mounting plate. Make sure to glue them to the end with a wider cutout.
Glue the PTO input to the front of the gearbox.
Glue the two pumps to the back of the gearbox as illustrated.
Glue the gate valve to the back of the Doda pump.

Step Two

Glue the assembly to the mounting plate.
Glue the mounting plate to the drawbar using the slot in the drawbar to align.
The gate valve may need trimming to get the fit correct.
Finally, add the pipe work to the top of the Doda pump, with the offset side hanging over the other pump.
Paint with the rest of the tanker.

Specifications

FAQ

Q: Can I paint the resin parts without cleaning them?
- A : No, it is important to clean all resin parts in warm soapy water to remove the silicone release agent before painting.
Q: What should I do if the gate valve does not fit correctly?
- A : The gate valve may need trimming to ensure a proper fit. Adjust it accordingly for a correct fit.
Q: How should I attach the assembly to the mounting plate?
- A : Glue the assembly to the mounting plate using appropriate adhesive or glue.
Q: Can I paint the product with the rest of the tanker?
- A : Yes, once the assembly is complete, you can paint it along with the rest of the tanker using suitable paint.

CLEAN ALL RESIN PARTS IN WARM SOAPY WATER

The silicone release agent used in the casting process will react with paint, it must be thoroughly cleaned off before painting.
This is a rough guide to using the kit. Care should be taken at each stage to make sure the model is going together correctly and any alterations that are not in the instructions should be carried out.
Paint : Components can be painted at any time in the build, it is a case of what suits the builder. We tend to use Automotive spray paints such as Halfords or Hycote or Hobby Paints like Humbrol, Revell or Tamiya.
Glue : Recommended glue is contact adhesive or super glue. Blue Lid Gorilla Super Glue is what we prefer.
Step On e. Glue the fins to either side of the mounting plate, glue them to the end with a wider cut out. Glue the PTO input to the front of the gearbox. Glue the two pumps to the back of the gearbox as illustrated. Glue the gate valve to the back of the Doda pump.
Step Two. Glue the assembly to the mounting plate. Glue the mounting plate to the drawbar using the slot in the drawbar to align. The gate valve may need trimming to get the fit correct. Finally add the pipework to the top of the doda pump, with the offset side hanging over the other pump. Paint with the rest of the tanker.