FORWARD CR50A-55 In Bench Vise Instructions
- June 14, 2024
- Forward
Table of Contents
Base Mounting
OPERATION
Mount vise to work surface in desired location by securing all mounting
flanges located on base. See Dimension drawing at back of document. Use four
3/8” diameter bolts, 2 inches longer than the bench top thickness, flat
washers and nuts (customer supplied).
Do not weld vise to any metal object. Make sure the bench top to which the
vise is mounted is properly secured.
The vise is shipped with a protective coating. This coating should be removed
before operation. Use penetrating oil to remove protective coating.
Secure vise in the desire rotational position by hand tightening the lock
handles. Do not use a pipe extension or cheater bar. This may cause handles to
bend and overstress locking bolt threads.
Open jaws of vise and place workpiece between jaws in desired position. Secure
workpiece between jaws by rotating leadscrew handle. Be sure workpiece is held
securely in vise. Never use hammer, pipe extension or cheater bar on leadscrew
handle of vise.
MOUNTING DIMENSIONS
NOT TO SCALE!
Documents / Resources
|
FORWARD CR50A-55 In Bench
Vise
[pdf] Instructions
CR50A-55 In Bench Vise, CR50A-55, In Bench Vise, Bench Vise, Vise
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>