SCOSCHE HA1714B In Dash Stereo Kit Installation Guide

SCOSCHE HA1714B In Dash Stereo Kit

INTRODUCTION / PRELIMINARY

This premium installation kit is for 2012-Up Honda CR-V vehicles. Included are all the parts you need to mount your car stereo or CD player into your vehicle’s dash. Refer to the individual instruction in this manual to remove your vehicle’s factory radio and assemble the kit.
CAUTION
Disconnect your vehicle’s negative battery terminal before the installation to help prevent electrical damage.
We recommend the use of a volt/ohm meter over a test light to check wiring. A test light or grounded wire probe can cause damage to the vehicle’s computer and/or diagnostic systems. Avoid all factory airbag wiring – airbags can accidentally deploy causing serious injury or death.
NOTES

• See your vehicle’s instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo for proper wiring and mounting instructions.

FACTORY WIRING CODES

For Factory Wiring Codes go to: www.scosche-cars.com

CAR STEREO CONNECTORS

PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO FACTORY WIRING HARNESS.

HA11B 2008-Up Honda

HAA2B 2006-Up Honda Antenna Adapter

LIABILITY DISCLAIMER

This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/ codes and information pertaining to installation of this kit (HA 1714B) in 2012-Up Honda CR-V vehicles. Scosche Industries, Inc. can not be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or options, or damage that may occur in the automobile during the installation of components while using this booklet.

FACTORY STEREO REMOVAL

2012-UP HONDA CR-V

1. With a panel removal tool remove A/C vents.
2.  With a pick tool unclip the hazard switch harness.
3. Extract (2) Phillips head screws securing radio, unplug and remove.
4. Extract (2) Phillips head screws securing the factory hazard switch, remove and retain for reassembly.

MOUNTING THE STEREO

SINGLE DIN-ISO MOUNT

1. Attach factory hazard switch to 7369 panel with screws removed during disassembly.
2. Attach 6552 pocket to 7369 panel using supplied screws (see left).
3. Attach the 7370 & 7371 brackets to 7369 panel with supplied screws.
4. Align and attach aftermarket single din stereo to the brackets using the screws supplied with the stereo. Note: If hardware is not supplied with aftermarket stereo use hardware from factory stereo.
5. Reconnect stereo and finish assembly.
   

DOUBLE DIN-ISO MOUNT

1. Attach factory hazard switch to 7369 panel with screws removed during disassembly.

2. Attach the 7370 & 7371 brackets to 7369 panel with supplied screws.

3. Align and attach aftermarket double din stereo to the brackets using the screws supplied with the stereo.
   Note: If hardware is not supplied with aftermarket stereo use hardware from factory stereo.

4. Reconnect stereo and finish assembly.
   

NOTE: REAR SUPPORT AVAILABLE SEPARATELY.
REAR SUPPORT OF THE STEREO ADDS TO THE INSTALLATION’S STRUCTURAL INTEGRITY.

References

• Scosche Tech Accessories | #1 Mount Brand in US & Canada

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>