PETLIBRO PLWF002 Ultra Quiet Pet Water Fountain 2.1L User Manual

PETLIBRO PLWF002 Ultra Quiet Pet Water Fountain 2.1L User Manual

SAFETY PRECAUTIONS

Warning

• Disposal of all packaging materials properly. Keep the polybags away from children and pets as these bags could cause suffocation.
• Do NOT allow children to play with, in or around the pet water fountain.
• To avoid injury, please keep close supervision when the appliance is used near children.
• Do NOT use the water fountain with pets not able to reach the water tray or with any physical disability.
• Do NOT place any foreign object in the water tank.
• Do NOT disassemble the pet fountain other than com- ponents as instructed in this User Manual.
• Do NOT use the pet fountain for anything other than its intended use.
• Only use attachments recommended or sold by the manufacturer. The use of attachments not recommend- ed or sold by the manufacturer may cause an unsafe condition. Do NOT modify the pet fountain.
• Do NOT operate any appliance if the unit is malfunc- tioning or has been damaged. Do not attempt repairs on the device yourself. Contact our customer service immediately for further instructions.
• Be sure to disconnect the power supply for safety when the appliance is not in use.
• Please disconnect the power supply before maintaining and cleaning the machine
• Always unplug the appliance when not in use; or before putting on or taking off parts and before cleaning.
• The power adapter and wire plug must not be flooded during cleaning.
• This product is for indoor use only.
• This product is not allowed to run without water.
• Never pull the electrical power cord to remove the plug from the wall outlet.
• If the plug of this device gets wet, turn off the electricity of that wall outlet. Do NOT attempt to unplug.
• Check the device after installation. Do NOT plug in if there is water on the contact points or plug.
• To avoid tripping, always position the power cord out of the way of foot traffic.
• Do not use the appliance in the bathroom.
• Change the filter every 2 weeks or when the flow rate has noticeably reduced. For two or more cats, you may need to replace the filters more regularly if it becomes blocked.

CAUTION

• Do NOT allow pets to chew on or swallow any parts. If you are concerned about the power cord, purchase a cord conduit (a hard-plastic protector) at any hardware store to protect the power cord.
• If an extension cord is necessary, one unit with a proper rating should be used.
• Do NOT install or store the pet water fountain where it will be exposed to weather or temperatures below 0°C/ 40°F.
• Read and observe all important notices listed on the pet water fountain and in the packaging.

This device complies with Part 15 of the FCC Rules. Oper- ation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired opera- tion.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.

NOTE :

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter- ference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni- cian for help.
  This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or trans- mitter.

Radiation Exposure Statement

To maintain compliance with FCC’ s RF Exposure guide- lines, This equipment should be installed and operated with minimum distance of 20cm from your body.

WARRANTY

• 1-year warranty
• Lifetime support

For guidance on product use and warranty extension, please contact our brand after-sales staff via email: [email protected].

If any questions related to orders, please contact the seller through the shaping platforme

PRODUCT OVERVIEW

1. Spout
2. Water Outlet
3. Water Tray
4. Filter
5. Filter Tray
6. Water Pipe
7. Water pump with power cord
8. Foam Filter
9. Charger
10. Soft Plug
11. Cord Slot
12. Water Tank

HOW TO USE

1. Soak the filter in a clean bowl for 5 minutes, then rinse the filter thoroughly with tap water.

Notes:

1. The filter must be fully soaked before the fountain is turned on; otherwise, water may not flow through the filter smoothly and cause spillage.

2. Do not soak the filter in the water tank of the fountain in case of any surface dust.
   

3. Position the pump according to the bottom slot shape. Press the pump to make the suction cups under the pump stick tightly. Put the cord in the slot.
   Note: The pump must be fixed in the right position in the tank.
   

4. Install the soft plug
   To prevent water leakage and secure the power cord in the cord slot, please align the cord slot when installing the soft plug.
   

5. Install the silicone pipe on the pump. Add water to the tanic
   Note: Keep the water level between the Min and Max level The pump will fall if it runs dry.
   

6. Install the filter tray and place the filter on the filter tray. Press down firmly to make sure the pipe outlet comes out.
   

7. Install the water tray. Whether to install the spout depends on your pet’s drinking preference.
   

8. Connect the power adapter.

CARE INSTRUCTIONS

1. Replace the filter and foam every 2 weeks.
2. Clean the pump and fountain every 2 weeks.
3. To extend the life of pump, please add water before starting the machine.

How to clean the pump

1. Remove the pump cover and impeller cover in sequence.
   Note: The foam filter is in the pump cover, change the foam every 2 weeks.
   

2. Remove the impeller by the brush hook.
   

3. Use the brush to lean the parts with water
   

Tip: The brush can also be used to clean the spout, Recommended to clean the spout every 2 weeks.

TROUBLESHOOTING

fully soaked. Please soak the filter in a clean bowl (not in the water tank) for 5 minutes before the first use.
The pump stops working.| 1)  Fill in water between MIN and MAX. The pump will fail if it runs dry.2)  Clean the pump, water tank, and drinking basin.3)  If the above solutions don’t work, please contact us at [email protected] .
How often should I change the filters? Where to get them?| It’s recommended to replace the filters every 2 weeks. Please contact us at [email protected] to purchase new filters.
Why do I need to soak the filter before first use?| The filters absorb more water (and therefore clean more water) when they’re wet and expanded. Soaking the filter removes particulate matter that may have settled on the filter.
Water output speed slows down.| For the first use (or reuse after long-time storage), the water pump needs to discharge air, it’s normal if the water output speed slows down.

SPECIFICATIONS

PLWF002 (ABS)

PLWF002 (ABS & Stainless Steel)

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>