Educational Insights EI-5133 My First Walkie Talkies Installation Guide
- June 16, 2024
- Educational Insights
Table of Contents
Educational Insights EI-5133 My First Walkie Talkies
Product Information
- Specifications
- Compliance: Part 15 of FCC Rules
- Battery Requirement: 6 AAA batteries (not included)
Product Usage Instructions
- Installation
- Ensure the device is turned off before installation.
- Locate the battery compartment on the device.
- Open the battery compartment by sliding the cover in the direction indicated.
- Insert 6 AAA batteries into the compartment, following the polarity markings.
- Close the battery compartment securely.
- Powering On/Off
- To power on the device, press and hold the power button for 2 seconds. The device will emit a startup sound and the indicator light will turn on. To power off the device, press and hold the power button again for 2 seconds.
- Operating the Equipment
- The equipment is designed for specific functions. Familiarize yourself with the buttons and controls by referring to the user manual provided. Follow the instructions in the user manual to navigate through different modes and settings.
- Adjusting Settings
- To adjust settings, use the dedicated buttons or knobs provided on the device. Refer to the user manual for detailed instructions on each setting and its functionality.
- Interference Handling
- This device is designed to accept any interference received, including interference that may cause undesired operation. If you experience interference, try moving away from other electronic devices or sources of interference.
- FAQ (Frequently Asked Questions)
- Q: What happens if I don’t use AAA batteries?
- A: The device requires 6 AAA batteries to function properly. If you do not use AAA batteries, the device will not power on.
- Q: Can I use rechargeable AAA batteries?
- A: Yes, you can use rechargeable AAA batteries. Ensure the batteries are fully charged before inserting them into the device.
WALKIE TALKIE BATTERY INSTALLATION
- Use a Phillips-head screwdriver to remove the battery door screw.
- Each walkie-talkie requires 3 AAA batteries, not included.
- Batteries must be inserted with the correct polarity.
- Do not mix old and new batteries.
- Do not recharge non-rechargeable batteries.
- Do not mix different types of batteries: alkaline, standard (carbon-zinc), or rechargeable batteries.
- Only use batteries of the same or equivalent type.
- Remove exhausted batteries from the walkie-talkie.
- Do not short-circuit the supply terminals.
- Only charge rechargeable batteries under adult supervision.
- Remove rechargeable batteries from the toy before charging.
- To prevent corrosion and possible damage to the product, it is recommended to remove the batteries from the walkie talkie it they will not be used for more than two weeks.
- Please retain these instructions for future reference.
GeoSafari® Jr. My First Walkie Talkies: are the world’s simplest walkie- talkies made just for kids! This set allows kids to talk to one another, indoors or outdoors, at the push of a button. The secure connection, single button, and handheld design make these the perfect beginner walkie-talkies. My First Walkie Talkies will take outdoor exploration and imaginative play to the next level!
TURN ON
After installing the batteries, slide the power switch to either low or high volume. When your walkie-talkie is on, the LED will glow red.
GET CONNECTED
- To connect with the other walkie-talkie, press the button on one unit. The light on both units will change to green to indicate they are connected.
- You can now talk without holding the button down.
- Your walkie-talkies have a range of up to 300 feet (90 meters).
TURN OFF
- When you are done exploring, press the connect button on either walkie-talkie to disconnect.
- The LED on both units will return to red. Make sure to also turn the power switch off so you don’t drain the batteries.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
LET’S KEEP EXPLORING WITH:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference and
- this device must accept any interference received, including interference that may cause undesired operation.
- Developed in Southern California by Educational Insights.
- All rights reserved. Made in China. ©Educational Insights, Torrance, CA, USA.
- Learning Resources Ltd., Bergen Way, King’s Lynn, Norfolk, PE30 2JG, UK.
- Learning Resources B. V., Kabelweg 57, 1014 BA, Amsterdam, The Netherlands Please retain the package for future reference. educationalinsights.com.
- REQUIRES 6 AAA BATTERIES (NOT INCLUDED)