Micro M156138 Light Therapy Lamp User Manual
- June 16, 2024
- micro
Table of Contents
Micro M156138 Light Therapy Lamp
Place the light therapy lamp on a table and make it open up. Connect the power adapter. Plug the power adapter into an electrical outlet(100-240V~ 50/60Hz).
- Power switch: Turn on/off the Light Therapy Lamp.
- Timer switch: 00(Steady on), 15min, 30min, 60min, 90min.
- Brightness switch: 20%,40%, 60%,80%, 100%.
- Digital display: Displays the current time or brightness.
- Wireless charging indicator light.
- Wireless charging position (Place the phone in the charging position.
- It supports 10W/7.5W/5W and automatically identifies the phone to charge.)
Warning
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference 1 may cause undesired operation.
FCC Warning Statement
This equipment has been tested and found to comply with the limits for Class B
digital devices, under part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used by the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE
This device complies with part 18 of the FCC Rules.
Information to the user.
- the device has potential interference, but the interference is very small and meets the requirements of the FCC rule
- Equipment system maintenance is simple, please refer to the manual
- The user can take simple measures to correct the interference. such as staying away from interference sources, turning off interference sources, etc.
RF exposure compliance statement
The equipment complies with the FCC Radiation exposure limit set forth for
uncontrolled environments. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>