50586 Hepa Filter For Dan Dryer Hand Dryers Installation Guide
- June 4, 2024
- DAN DRYER
Table of Contents
50586 Hepa Filter For Dan Dryer Hand Dryers
INSTALLATION GUIDE
Introduction: This guide shows how to properply install a DAN DRYER
HEPA filter 50584/50586.
Warning: To achieve the best possible result, it is important that the
filter’s particle filter (green without ribs) is facing outward.
BJÖRK
- Locate the mounting holes on the foot of the dryer. Remove the existing filter holder, if any, before the new unit can be installed.
- Place the filter unit on the holes over the air inlet.
- Fit and fully tighten the security screws on both sides.
- Installation/replacement of the filter is now complete.
TURBO Low Noise
- Locate the mounting holes on the foot of the dryer. Remove existing filter holder, if any, before the new unit can be installed.
- Place the filter unit on the holes over the air inlet.
- Fit and fully tighten the security screws on both sides.
- Installation/replacement of the filter is now complete.
AirTap
1. Locate the mounting holes on the foot of the dryer. Remove existing filter
holder, if any, before the new unit can be installed.
2. Place the filter unit on the holes over the air inlet.
3. Fit and fully tighten the security screws on both sides.
4. Installation/replacement of the filter is now complete.
- DAN DRYER A/S
- Alsikevej 8 DK-8920 Randers NV
- +45 86 41 57 11
- info@dandryer.com
- www.dandryer.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>