SWIT TD-R230S 48V 750W Light Stand Power Adaptor User Manual
- June 16, 2024
- SWIT
Table of Contents
TD-R230S
Light pole dual battery Snap-On adapter
SWIT Electronics Co.,Ltd.
USER MANUAL
TD-R230S 48V 750W Light Stand Power Adaptor
choosing SWIT products, Please read the instructions before using and keep it for future reference.
WARING
- Do not allow the adapter to come into contact with rain.
- Keep the electrodes clean and do not allow a short circuit between them
- Make sure that the power of the equipment using the electricity meets the battery specifications.
- Please mount the adapter reliably on a stand to prevent serious damage due to drops.
characteristics
- compatible with SWIT high voltage and dual voltage batteries and can output up to 48V/750W with the SWIT HB-C420S 3-core XLR connector.
- One SPEAKON interface, supports 22~33.6V battery direct out power.
- Dual LEDs for individual channel status indication.
- Compatible with tripods with diameters from 25mm to 45mm.
- Small size and innovative finless cooling design for quieter and more convenient use.
- Symmetrical design for a more stable centre of gravity.
Description of appearance
- Locking device
- LED indicator
- Vmount plate
- Mounting brackets
- 48V 3-core XLR
- Adapter switches
- SPEAKON
Oversize
| Model | TD-R230S |
|---|---|
| Output interface | 3-core XLR |
| Input voltage range | Starting voltage: 25.6-35V |
Under voltage value: 23V
Output power| 750W. 48V 15.6A| 750W . 22-33.6V 17.4A
Operating temperature| -20-40t
Net weight| Around 1.3kg
SIZE| 146123110 mm
Note：
- It is recommended to use the same type of battery with the same power level；
- 48V/750W output with SWIT HB-C420S only
- With other batteries mounted, the maximum output power is the maximum output power of the adapter or the sum of the outputs of the two batteries (whichever is smaller)
- The 3-core XLR output can only be turned on when the battery is mounted at a voltage in the range of 25.6~35V; the 3-core XLR output is turned off when the battery is discharged at a voltage below 23V.
Instructions
- When the adapter switch is switched off, the LED indicator goes out and there is no output from the discharge port.
- LED indicator：
Indicator status
Green| The battery is reliably mounted and the current channel is normal.
Slow flashingred light| The battery is about to run out of power, please
replace the battery as soon as possible.
Red| The battery is depleted.
Red light flashing| In case of short circuit, over current, over temperature
protection and other abnormal conditions, please unplug all the batteries and
cables, wait for the adapter to drop to room temperature or re-plug the
batteries can be restored.
Tel：025-85805295
Fax：025-85805296
http://www.swit.cc
E-mail: xsb@swit.cc
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>