SWIT FL-C100 LED Spot Light User Manual

: October 30, 2023
: SWIT

Table of Contents

Specification
Appearance
Usage
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FL-C100 LED Spot Light
User Manual

Thank you for choosing SWIT products. Please read the instructions before using, and keep it for future reference.

Specification

Model	FL-C100
Half Beam Angle	12°-26°
Color temperature	5600K
CRI	96
TLCI	97
SSI(D55)	74
Max Illuminance	60000Lux@Lm(Spot)/22000Lux@Lm(Flood)

SWIT FL C100 LED Spot Light - Dimension

Appearance

SWIT FL C100 LED Spot Light - Appearance

1. USB
2. LCD
3. AC OUTPUT
4. AC INPUT
5. POWER Switch
6. Flood/Spot knob
7. DMX OUTPUT| 8. Adjustable Handle
9. DMX INPUT
10. Dimmer Knob
11. Barn Door
12. Bracket Adaptor
13. Hanging Ring install hole
---|---

Caution

Do not disassemble the light or touch the interior of the light with metal objects, so as not to cause damage;
Please avoid storing lights in dusty or humid environment to avoid damaging or affecting the usage;
In order to avoid accidental dropping and damage of the barn doors during transportation, please reduce the light head to the minimum position for storage;
Use this product only within the temperature range of -10 °C – 40 °C.

Usage

Installation
Before use, please install the barndoor and honeycomb according to the requirements. When lifting and using the lamps, please pass the safety rope (hereafter referred to as “safety rope”) through the hanging ring and the bracket(Hanging ring need to be installed in Fig.4 ⑬ ).
Power supply
The working voltage of this light is AC 100-240V, 50/60Hz, Support AC loop out.
Brightness and DMX address setting
This product is a 5600K spotlight. After the power is switched on, users can adjust the brightness parameters of the lamp through the DMX lamp console or brightness adjustment knob according to the requirements of use. The specific operation of adjusting brightness of lamps through DMX controller is as follows:
• DMX Control
Each lamp occupies a total of one DMX channel. If the DMX address set for the lamp is N, then the N channel of the DMX lamp console controls the luminosity parameter of the lamp. If the DMX address set for the lamp is 001, then the relevant control channel and functions of the lamp console are shown in Table 1:

Form.1

DMX Communication Address| Function
CH1| Brightness 0%-100%

• DMX Address setting
Hold the brightness adjustment knob (As shown in Figure 3 ⑩) for about 2 seconds to enter the communication address setting interface. The communication address setting range is 001-512. The LCD (Figure 3 ②) blinks, indicating that the current position is selected. Rotate the brightness adjustment knob (Figure 3 ⑩) to set the current position and press the brightness adjustment Knob (Figure 3 ⑩) to determine the current bit Settings and enter the next bit Settings. When the last bit Settings are completed, press the brightness adjustment knob (Figure3 ⑩) or wait for about 5 seconds to exit the communication address Settings

Flood/Spot
Rotate the Flood/Spot knob clockwise, the light will change from Flood to Spot, Rotate the Flood/Spot knob anticlockwise, the light will change from Spot to Flood.

Packing List