TAP HALN 3 STR Positions Single Coil Owner’s Manual
- June 9, 2024
- TAP
Table of Contents
HALN 3 STR Positions Single Coil
Owner’s Manual
Installation and Wiring Diagram
FEATURES
This Stratocaster type pickups utilizes alnico 5 magnets in a internal vintage
staggered configuration. Comes with the more expensive Plain Enamel magnet
wire. Of course the pickup is insulated and shielded to avoid unwanted
microphonic. We have discovered the winding technique to achieve best quality
and a full, warm sound and pushed these qualities even further.
The pickup has an extremely clean start tone. Treble response is smoother, the
lows are tighter, and there is more pick attack.
Play hard, and the sound jumps out of the amp. Play softer, and the sound
becomes cleaner and quieter. These qualities are really useful for getting a
fat neck position sound and makes a good neck and middle choice to match with
a full-size bridge humbucker.
‘Tip’ for TAP complete setup The TAP set (3 pickups) available with
reverse polarity (RW/RP) on the middle pickup for hum canceling.
INSTALLATION
Remove the strings and the pick-guard from your guitar. De-solder the guitar pickup’s wires, and remove pickups from the cavity. Put the TAP pickups into the pickup cavity and then solder wires. Re-string your guitar. By adjusting the pickup height, adjust the screws at both sides of the pickup, to set the height of the pickup with the string pressed at the last fret There should be a space of 2-3mm (1/8″-1/16 th”) between the pickup and the strings.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>