GREEN Notus 100 PWM CPU Air Cooler User Manual

Table of Contents

Notus 100 PWM CPU Air Cooler
User Manual

Intel Socket 1200/1700/1150/1151/1155/1156 CPU

AMD Socket AM5/AM4/AM3+/AM3/AM2+/AM2/FM1/FM2/FM2+ CPU &APU

To ensure safe and easy installation, please read the following precautions

Avoid inserting objects or hands into the fan while it is in operation to prevent product damage and injuries.
Do not ingest the Thermal Grease, and avoid its contact with skin and eyes.
If contact is made with skin, wash off with water. If ingested or irritation persists, seek medical attention.
To prevent possible injuries, gloves must be worn while handling this product.
Excessive force exerted on the fan may cause damage to the fan and/ or system.
Use and keep product away from reach of children.
Check the components list and condition of the product before installation.
If any problem is found, contact the retailer to obtain a replacement.
During transportation of the system, the cooler must be removed. GREEN is not responsible for any damages that occur during the transport of a system.
product designs and specifications may be revised without prior notification to improve quality and performance.

Components

Space Requirements
The cooler’s installation requires an unobstructed space of 74 mm(width) 104mm(length),and 130mm(height), with the CPU as a central reference point, Please check if components such as ODDs and PSU protrude into the required space.
Air Guide Removal
Air guides on enclosures must be removed before the Cooler’s installation since they protrude into the cooler’s required space.
Cooler Orientation
As shown in the diagram below, it is recommended that the cooler be installed so that air flows from the cooler toward the enclosure’s rear exhaust fan to be released.
Recommended cooler orientation may differ according to the motherboard model.

Intel Socket 1200/1150/1151/1155/1156/1700Installation ·Install the Clip Support to the motherboard according to the socket type. (See diagram)
Align the Clip Support to the motherboard and fasten with the Pushpins.
Clear off any particles or residue from the CPU’s surface. Then spread a thorough layer of Thermal Grease on the CPU and the base of the cooler.
install the cooler on the clip support as shown in the picture and connect the lug slot of the clip on to the lug on the clip support. Then one hand press CPU cooler to keep level and the other hand press clip to connect the other lug slot of clip on to the other lug of the clip support.
Connect the cooler’s 4-pin PWM connector to the motherboard’s CPU Fan header.

4MD Socket AM5/AM4/AM3+/AM3/AM2+/AM2/FM1/FM2IFM2+ Installation

Clear off any particles or residue from the CPU’s surface. Then spread a thorough layer of Thermal Grease on the CPU and the base of the cooler.
Install the cooler on the clip support as shown in the picture and connect the ug slot of the clip on to the lug on the clip support. Then one hand press CPU cooler to keep level and the other hand press clip to connect the other lug slot of clip on to the other lug of the clip support.
Connect the cooler’s 4-pin PwM connector to the motherboard’s CPU Fan header.

To ensure safe and easy installation, please read the following precautions
www.green.ir