PYRAMID 072499 Yamaha MT-10 Hugger Installation Guide
- June 15, 2024
- PYRAMID
Table of Contents
**PYRAMID 072499 Yamaha MT-10 Hugger Installation Guide
**
Kit Includes:
| 1 | X1 | 072499M | MT-10 Hugger Moulding |
|---|---|---|---|
| 2 | X1 | CFK072499 | Mounting Bracket |
| 3 | X3 | CBOLM60008 | M6 x 16mm Button-Head Screw |
| 4 | X3 | CWASM60001 | M6 Flat Washer |
| 5 | X3 | CWASM60002 | M6 Shakeproof Washer |
| 6 | X1 | CPNUTM6000 | M6 Rivet Nut |
| 7 | X1 | OEM MT-10 | Brake Wire Clamp |
| 8 | X1 | OEM MT-10 | M6 x16mm Button-Head Screw |
Please Note: The M6 Rivet Nut is already pre-located on the supplied bracket, ‘CFK072499’
Assembly Instructions
The Pyramid Hugger utilises the mounting locations of the OEM hugger and the OEM components listed above.
- When removing the existing hugger, please retain the brake wire clip (Item 7). Once removed, locate the brake wire clip in the hole marked in ‘FIG 1’.
- Unscrew the OEM M6 screw (Item 8) holding the secondary brake wire clip. This will allow for the bracket to be mounted. Re-insert the OEM M6 screw, along with the Hugger Bracket (Item 2), so that the bracket shape follows the form of the MT-10 swingarm. Please do not tighten until the hugger has been fitted.
- Using the assortment of M6 screws and washers provided, now proceed to fit the hugger in place. Please ensure that no screws are tightened until all mounting points have been located.
- Once fitted, continue to tighten all mounting points. Please see Page 2 for component details.
**Please Note: We advise that all fixings are checked periodically.
**
The images below images will assist with identification and application of the components provided in the fitting kit
Figure 2 details where the bracket should be fitted, together with the OEM M6 screw.
Please take note of the orientation of the bracket.
Any questions?
[email protected]
+44 (0)1427 677990
www.pyramid-plastics.co.uk
Follow us on social media and
feel free to leave us a review!