Comfort Zone CZFP1 1200-Watt Mini Fireplace Heater User Manual

June 15, 2024
Comfort Zone

Comfort Zone CZFP1 1200-Watt Mini Fireplace Heater

Comfort Zone-CZFP1-1200-WatT- Mini-Fireplace-Heater-
PRODUCT

Features

  • Realistic LED 3-D Flame Effect
  • Three Settings:
    • High (1200 watts – 4095 BTUs)
    • Low (600 watts)
    • 3-D Flame Only
  • Fan Forced Air Circulation
  • No Venting Required
  • Stay Cool Composite Body
  • Safety Tip-Over Cutoff Switch
  • Safety Overheat Protection
  • 120V A.C. / 60Hz. 10.0 Amps

INSTRUCTIONS

INTENDED USE:
This product is intended for indoor residential and office use only, not for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician. Use your heater only with a working smoke detector located in the vicinity of your heater. While using your heater, you should follow the IMPORTANT INSTRUCTIONS are listed below. As part of those instructions, we have used the word
WARNING ” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result in injury or death.

IMPORTANT INSTRUCTIONS

As with all electrical appliances, basic safety precautions should always be followed to reduce the risk of electric shock, fire, or injury to persons, including the following precautions:

  • Read all the instructions before using this heater.

  • Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause electrical shock, fire or damage to persons or property.

  • Do not operate the heater with a damaged power cord or after the heater malfunctions or has been dropped in any manner.

  • Do not use with cracked or broken glass.

  • Do not use heater unattended. Use of extreme caution is necessary when any heater is used by or near children, disabled persons or pets.

  • Do not place the heater on a small, unlevel, uneven or any surface that might allow heater to tip or fall.

  • For proper operation, the heater should be placed on a smooth, non-combustible surface. Do not place on rugs or carpet.

  • Always unplug the heater when not in use.

  • Do not operate the heater with heater guards or any safety device removed.

  • Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).

  • Do not run the power cord under the carpeting. Do not cover the cord with throw rugs, runners or the like.
    Arrange the cord away from the traffic area where it will not be tripped over.

  • WARNING: SHOCK HAZARD
    Use your heater only in dry environments. This heater is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate the heater where it may fall into a bathtub or other water container. Do not use heater outdoors. Do not use in damp environments such as flooded basements.

  • WARNING : HOT SURFACES

  • Do not touch the body of the heater when in use. This heater is hot when in use, to avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater.

  • WARNING : FIRE HAZARD

  • The heater has hot and arcing or sparking parts inside. Do not use near combustible materials or flammable gases or sources of heat. DO NOT USE in areas where gasoline, paint or flammable materials are used or stored. This heater is hot when in use. If provided, use handles when moving this heater. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. Do not place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater

  • WARNING: ELECTRICAL SHOCK HAZARD

  • Do not use a damaged cord or plug. Use with adequate electrical system that is up to code.

  • The supply cord has a polarized plug. As a safety feature, this plug will fit in a polarized outlet only one way. To prevent electric shock, match wide blade of plug to wide slot, fully insert plug. If the plug does not fit contact a qualified electrician. Never use an extension cord. DO NOT attempt to defeat this safety feature.

  • Do not operate any heater with a damaged cord or plug or after heater malfunctions, has been dropped or damaged in any manner. Do not operate heater with a broken heating element or ceramic cone or any visual imperfections. For repairs covered under warranty, see warranty statement. For all other repairs contact Comfort Zone’s Customer Service by telephone or mail for information and assistance.

  • DO NOT run the power cord under the carpeting. DO NOT cover the cord with throw rugs, runners or the like. Arrange cord away from traffic area where it will not be tripped over.

  • Always plug the heater directly into a wall outlet/receptacle.

  • Never use an extension cord or relocatable power tap (outlet/power strip). Unplug the heater when not in use. Do not operate heater with its ventilation obstructed.

USAGE

  • HEATER OPERATION: Always operate the heater in the upright position following all instructions and recommendations listed in this manual HEATER
  • LOCATION: Place the heater in the area of the room that is coldest.
  • HEATER CONNECTION: Plug the heater directly into 120 volts A.C., 60 Hz wall outlet. Be sure the plug fits tightly in the outlet. A loose connection may cause overheating and damage to the plug or heater. NOTE : To prevent overloading a circuit, do not plug the heater into a circuit that is servicing other electrical needs.

TURNING HEATER ON:

  • For LED Flame Effect Only – Rotate Power On/Off Flame Control switch to FLAME Setting. The indicator light will come on.
  • For Low Heat (600 watts) – Rotate the Power On/Off Flame Control switch to a LOW position. Fan will operate at full speed, and power to the ceramic element will be limited to 600 watts.
  • For High Heat (1200 watts) – Rotate Power On/Off Flame Control to HIGH position. The fan will operate at full speed, 1200 watts of power is delivered to the ceramic elements.Comfort Zone-CZFP1-1200-WatT- Mini-Fireplace-Heater-FIG.1
  • ROTARY POWER ON/OFF FLAME CONTROL: This heater has two heat settings: HIGH and LOW. Use the higher setting (1200 watt) to raise the room temperature quickly. When the desired temperature is reached use the LOW (600 watt) setting. It is usually sufficient to maintain a comfortable temperature.
  • POWER INDICATOR: The Power Indicator Light located on the switch will illuminate when the Power On/Off Flame Control switch is turned on any setting.
  • TO OPERATE SIMULATED FLAME ONLY: Rotate the Power On/Off Flame Control switch to FLAME to have the flame effect without any heater functions.
  • TURNING OFF: Turn the Power On/Off Flame Control to OFF to discontinue use. The heater should be unplugged when not in use.

IMPORTANT SAFETY FEATURES

The power indicator light, located near the Power On/Off Flame Control switch, lights whenever the heater is turned on any setting to tell you that the heater is functioning properly. The heater is equipped with an automatic overheat protection device located inside the body of the heater. If the heater grill is obstructed, or if the heater gets too hot for any reason, the automatic overheat protection device will turn the heater off. To reset the heater, simply turn the power off and unplug the heater for 20 minutes until it cools down and you may plug the heater in and restart the heater. Be sure that the heater is on a smooth level surface with no obstructions. The heater is also equipped with a safety tip-over switch to turn power off to the heater when the heater tips over. To resume heater functions simply stand heater upright. Be sure that the heater is on a smooth level surface where the heater will not be accidently tipped over.

CARE AND MAINTENANCE

  • CLEANING : CAUTION- Before cleaning the heater be sure to disconnect the power cord and allow the heater to cool completely. Clean the outside surface with a clean damp cloth. Do not use harsh chemicals or abrasive cleaners. DO NOT IMMERSE THE HEATER IN WATER. Allow the heater to dry completely before use. Use a vacuum or duster to keep heat and vent area clean and free of dust and dirt.
  • REPAIR : DO NOT OPERATE THE HEATER WITHOUT THE GRILL IN PLACE. DO NOT USE THE HEATER IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
  • STORAGE : Keep the original carton for storage of the heater. Coil and tie the power cord to avoid damage during storage.

LIMITED WARRANTY

Products manufactured by Comfort Zone® are warranted to the original consumer to be free of defects in material and workmanship for twelve (12) months from the original date of purchase. The warranty does not cover products modified outside our factory, damage or failure caused by acts of God, abuse, misuse, abnormal usage, faulty installation, failure to follow suggested maintenance procedures enclosed with this product (as defined by Magnuson-Moss Warranty- Federal Trade Commission improvement Act) This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for one year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days of purchase, return the unit, with your receipt, to the retailer. After 30 days, but within the warranty period, if the unit was purchased within the continental United States, return it, freight prepaid, to Comfort Zone® for repair or replacement. If the unit was purchased outside the continental United States, return the unit to the place of purchase. This warranty does not cover damage due to accidents, or operation on other than 120 volts, 60 hertz, AC. current, or any other abuse. All implied warranties, including the warranties of merchantability and fitness of purpose, if applicable, are hereby limited in duration to the period of one year from the date of original retail purchase. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Incidental or consequential damages arising from a breach of either express or implied warranties are hereby disclaimed and excluded. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. No informal dispute settlement mechanisms are available. This limited warranty is given instead of all other warranties.
Manufactured by: Comfort Zone® 324A Half Acre Rd. Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneheaters.net
rev 072911

FAQs

Q: Can Comfort Zone CZFP1 be used for decorative purposes only, without heating?

A: Yes, Comfort Zone CZFP1 can operate with the flame effects turned on without producing heat, serving as a decorative piece.

Q: How does Comfort Zone CZFP1 create the illusion of flames?

A: Comfort Zone CZFP1 uses LED technology to produce realistic flame effects without the need for actual flames.

Q: Does Comfort Zone CZFP1 mimic the appearance of a real fireplace?

A: Yes, Comfort Zone CZFP1 is designed to resemble a traditional fireplace, complete with realistic flame effects.

Q: Is Comfort Zone CZFP1 portable?

A: Yes, Comfort Zone CZFP1 is a portable heater, making it easy to move around your home as needed.

Q: What is the heating capacity of Comfort Zone CZFP1?

A: Comfort Zone CZFP1 has a heating capacity of 1200 watts, making it suitable for heating smaller rooms.

Q: What is Comfort Zone CZFP1?

A: Comfort Zone CZFP1 is a 1200-watt Mini Fireplace Heater designed to provide warmth and ambiance to small spaces.

Q: What is the approximate size of Comfort Zone CZFP1?

Q: Does Comfort Zone CZFP1 require any assembly?

A: Comfort Zone CZFP1 usually comes pre-assembled, and you may only need to attach the legs or stand, depending on the model, for easy setup.

Q: Can Comfort Zone CZFP1 be used as a primary heat source in larger rooms?

A: Comfort Zone CZFP1 is better suited for supplemental heating in smaller spaces rather than serving as a primary heat source in larger rooms.

Q: Does Comfort Zone CZFP1 come with a remote control?

A: Yes, Comfort Zone CZFP1 typically includes a remote control for convenient operation from a distance.

Q: How does Comfort Zone CZFP1 distribute heat?

A: Comfort Zone CZFP1 utilizes a fan-forced heating system to evenly distribute warm air throughout the room.

Q: What safety features does Comfort Zone CZFP1 have?

A: Comfort Zone CZFP1 is equipped with safety features such as overheat protection and a cool-touch exterior to prevent accidents.

Video- Comfort Zone Heater Line-Up

Download This Manual PDF:Comfort Zone CZFP1 1200-Watt Mini Fireplace Heater User Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Comfort Zone User Manuals

Related Manuals