KFi PRODUCTS Kioti K9 Plow Mount Instruction Manual
- June 15, 2024
- KFi PRODUCTS
Table of Contents
KFi PRODUCTS Kioti K9 Plow Mount
Product Information
Kioti K9 Plow Mount PART #106595
Specifications:
- Kit Components:
- Item #1: Plow Mount Hardware Kit HK-419
- Item #2.1: M12-1.75 X 30 Hex Bolt Flange GR8.8
- Item #2.2: M10-1.25 X 30 Hex Bolt Flange GR8.8 (6 not used)
Installation Instructions:
Note:
Make sure all hardware needed to complete this mount is in the package.
Thoroughly read through and understand the instructions before installing.
Figure 1:
- Remove the 2 bolts (A) located just behind the front differential as shown in Figure 1. These bolts will not be reused.
- Place plow mount (1) up to the frame, allowing the receiver to protrude through the mount as shown in Figure 2. Install bolts (2.1), do not fully tighten.
- Use bolts (2.2) to attach the rear of the mount to the frame as shown in Figure 2.
Figure 2:
Once all of these bolts are started, they can be tightened evenly.
FAQ:
-
Q: What is included in the kit?
A: The kit includes a plow mount hardware kit (HK-419), M12-1.75 X 30 Hex Bolt Flange GR8.8 (2.1), and M10-1.25 X 30 Hex Bolt Flange GR8.8 (2.2). -
Q: Can the bolts be reused?
A: No, the two bolts located just behind the front differential need to be removed and will not be reused.
Kit Components
| item # | Qty. | Description |
|---|---|---|
| 1 | 1 | Plow Mount |
| 2 | 1 | Hardware Kit HK-419 |
| 2.1 | 4 | M12-1.75 X 30 Hex Bolt Flange GR8.8 |
| 2.2 | 2 | M10-1.25 X 30 Hex Bolt Flange GR8.8 (6 not used) |
INSTALLATION INSTRUCTIONS
Note:
Make sure all hardware needed to complete this mount is in the package.
thoroughly read through and understand the instructions before installing.
- Remove the 2 bolts (A) located just behind the front differential as shown in Figure 1. These bolts will not be reused.
- Place plow mount (1) up to the frame, allowing the receiver to protrude through the mount as shown in Figure 2. Install bolts (2.1), do not fully tighten.
- Use bolts (2.2) to attach the rear of the mount to the frame as shown in Figure 2.
- Once all of these bolts are started, they can be tightened evenly.
©2023 Copyright Kappers Fabricating, Inc. All rights reserved