Geocities TRD FJ Roof Basetet User Manual
- June 15, 2024
- geocities
Table of Contents
Geocities TRD FJ Roof Basetet
Roof basetet Users Manual model year: 2020
-
take out the double pipe fittings on the left and right sides.
-
align it with the label.
(small Land R libels are affixed on the tub@.)tube. -
insert into the back double-layer
-
adjust the accessories so that the holes of the three layers of accessories are aligned. (inner tube, outer tube stamping iron parts.)
-
screw fn bolt-A and gasket-A (no l0<king.)
-
wait until all 4 bolts are screwed in and then lock the one by one.
-
take- out all the side covers A&B . (A&B is a group of four.)
-
put in the rubber ring as shown. { Tip : Put the washer on one side.)
-
look the picture on the left, limital the side cover of the rubber ring fasten to each other.
(the cylinder shall pass through the round hole in the middle of the stamping iron.) -
screw blot-B in the hole B of cover.
Note : after fastening, the surface should be smooth as shown in the picture on the right.
-
look the picture. install the 4 side covers one by one.
Note : check if the installation is. firm. -
look the picture ,install the front tend rear mounting bases
Note : there is a direction identification symbol on 1h -
look the picture, turn the frame over and screw in the bolt-A, gasket-A.
-
put on the front and back rubber pads
-
look the picture ,Install bladerubbers cushion in turn
Note :check whether the base fandubber pad are installed correctly wilt the strong -
refer to the five cross. bur positions shown In the drawing after adjustment, lock in turn
- Refer to the picture, put the rubber block In the roof rain trough. and then place the frame on the roof, aiming at the hole position, screw in bolt- D, gasket (lock the front end first, then the back end)
Note : check all acce1.sories for omissions
installation is complete
Documents / Resources
|
Geocities TRD FJ Roof
Basetet
[pdf] User Manual
TRD FJ Roof Basetet, TRD FJ, Roof Basetet, Basetet
---|---