ULINE H-88 Industrial Handwrapper Instructions
- June 7, 2024
- ULINE
Table of Contents
ULINE H-88 Industrial Handwrapper
LOADING AND UNLOADING INSTRUCTIONS
TO LOAD FILM ONTO HANDWRAPPER
NOTE: Handwrapper comes preset at 12″ height. Must unthread completely to use larger rolls.
- Unscrew the top knob (turn counterclockwise) about 1/2 inch. Remove the slotted top core holder by sliding it out of the threaded rod section. (See Figure 1)
- Slide the film roll over the top knob and position the film core over the bottom core holder.
- Take the top core holder and slide it back through the threaded rod section. Drop it into the top of the core.
- Screw the top knob clockwise until it holds the top core holder in place.
TO REMOVE FILM FROM HANDWRAPPER
- Unscrew the top knob (turn counterclockwise) about 1/2 inch. Remove the slotted top core holder by sliding it out of the threaded rod section. (See Figure 1)
- Remove the film by sliding it over the top knob.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>