hpi-racing TF-51 FHSS Radio Control System Instruction Manual
- June 15, 2024
- hpi-racing
Table of Contents
**hpi-racing TF-51 FHSS Radio Control System Instruction Manual
**
Transmitter Features
Steering Wheel Adjustment
The steering module on the TF-51 can be swapped from one side of the Transmitter body to the other. This allows for Left as well as Right handed use.
*This step same for left and right
Magnetic Area
Magnetic area suitable for securing bodyclips or small screws while working on your RC vehicle .
Transmitter Preparation
Transmitter Battery Installation
Open battery cover at the bottom of transmitter. Install batteries. As shown in picture.
101939 (US/EU)
Receiver Connections
Mount receiver and servo in chassis according to your chassis instruction.
Transmitter Preparation
Binding Setup
programming a receiver to recogniz the code only one specific transmitter
Caution
If you change transmitters or add a receiver, you must re-bind before operating your vehicle.
Place the transmitter and the receiver close to each other (within one meter). Turn the power switch on the transmitter to the ON position.
Hold the button down.
Press and hold the receiver setup button, then turn the power switch to the ON position. The receiver LED will flash quickly. Release the setup button after 1 second.
Press and hold the binding button on the transmitter for 1 second until the LED on the receiver is continuously lit.
**Transmitter Preparation
**
Fail Safe Setup
This car has a built-in fail safe system. If the radio glitches, because of
interference or the car goes out of range, the servo will apply the brakes to
protect your car.
The fail safe system has been setup at the factory, but you should become
familiar with the function of the fail safe and check the operation before
running.
Situations when the fail safe will operate.
-
When transmitter radio signal is cut off.
-
When receiver battery charge is low.
The fail safe can not completely protect your car.
Caution
Any new binding of transmitter & receiver will clear the preset fail safe.
Turn the power switch to the ON position on the transmitter. Turn on receiver. Press the setup button on the receiver then release. LED will flash
Electric setup.
Leave throttle trigger in neutral position, and press the setup button. The
LED will flash quickly.
Once the receiver LED remains lit, then release the setup button on the
receiver.
Nitro setup.
Hold full brake on the transmitter, and press the setup button. The LED will flash quickly. Release full brake on the transmitter once the receiver LED remains lit, then release the setup button on the receiver.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>