hpi-racing HPITF51S0001 Radio Control System Instruction Manual
- June 15, 2024
- hpi-racing
Table of Contents
hpi-racing HPITF51S0001 Radio Control System
Transmitter Preparation
Electric setup
To confirm that fail safe is working properly, the ESC will go in to the
neutral position and the vehicle will not move when you shut off the
transmitter. See page 6 and check the Fail Safe function working properly. You
do not need to repeat this procedure each time you run.
Nitro setup
To confirm that fail safe is working properly, full brake should automatically
be applied when you shut off the transmitter. See page 6 and check the Fail
Safe function working properly. You do not need to repeat this procedure each
time you run.
Hold the button down.
Transmitter will emit an audible beep after 15 mins of inactivity as a reminder to turn it off.
Transmitter Preparation
End Point Adjustment / EPA
End point adjustments allow you to set the limits of steering and throttle.
Caution
Do not adjust the servo beyond its limit. Damage may occur.
Turn the power switch to the ON position on the transmitter. Turn on the receiver. Place the car on a stand and adjust steering and throttle trim, then turn dual rate to maximum setting.
Turn steering wheel all the way to the left and adjust your end point to the desired angle.
Damage to your servo may occur if your maximum steering endpoints are set too
far
Turn steering wheel all the way to the left and adjust your end point to the desired angle.
Damage to your servo may occur if your maximum steering endpoints are set too
far.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>