BLAUPUNKT BPA-C1000 Mono Block Class D Amplifier User Manual

: June 15, 2024
: Blaupunkt

Table of Contents

BLAUPUNKT BPA-C1000 Mono Block Class D Amplifier
System planning
Speaker requirements
Power Connection Leads
Specifications
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BLAUPUNKT BPA-C1000 Mono Block Class D Amplifier

System planning

system planning is the best way to maximize your amplifier performance.
By planning your installation carefully you can avoid situations where the performance of the reliability of your system is compromised.
Your authorized dealer has been trained to maximize your system’s sonic potential.
Your dealer is a valuable resource in helping you with your system design and installation.

Speaker requirements

Each channel Of your amplifier can easily drive 4Q speaker loads when used in the stereo mode.
When a channel pair is bridged, the recommended minimum load impedance is 30 for subwoofer use and 4Q for full range operation.
Although operation with lower impedances is not likely to cause immediate damage to the internal circuitry, the unit will most likely overheat, causing the thermal protection circuitry to shut down the amplifier.
When the chassis cools down, normal operation will resume. Continuing to operate the amplifier under these conditions is not recommended and will reduce its life expectancy.
Most speakers designed for car audio operation have 4Q impedance. Connecting two such speakers in parallel will result in a 20-impedance load as seen by the amplifier.
Some subwoofer models feature a dual 4Q voice coil design.
Connecting these voice coils in parallel will result in a 20 nominal impedance, which is not recommended for use with bridged channels of your amplifier.

Power Connection Leads

Notes on the power supply

Connect the + 12V power input lead only after all other leads have been connected.
Be sure to connect the ground wire of the unit securely to a metal part of the car.
A loose connection may cause a malfunction of the amplifier.

REMOTE: The unit is turned on by applying + 12 Volts to this terminal This terminal does not draw heavy current like the two power terminals so a thinner connecting wire is acceptable.

Standard 18 GAUGE is fine and the standard colour is yellow.
If the radio is equipped with a power antenna control wire, it can drive this terminal.
If the power antenna wire is already in use, you can still splice into it.
With this method, the unit will turn on automatically with the radio.
Use the power supply lead with a fuse attached whose value is the same as the original fuse.
Place the fuse in the power supply lead as close as possible to the car battery.
During a full power operation, Maximum current will run through the system.
Therefore, Make sure that the leads to be connected to the + 12v and GND terminals of the unit respectively must be larger than 10-Gauge (AWG. 10).

System 1: 2-channel mode

System 2: 1 channel mode

system 3: 2 amplifier linked to 1 channel

Power Connection Leads