BLAUPUNKT BPS-E452 2 Way Car Speaker System User Manual

June 15, 2024
Blaupunkt

BLAUPUNKT BPS-E452 2 Way Car Speaker System User Manual

BLAUPUNKT BPS-E452 2 Way Car Speaker System User
Manual

BLAUPUNKT BPS-E452 2 Way Car Speaker System User Manual -
Model

WIRING

Blaupunkt Speaker wired to a single channel Total Impedance: 4 ohms x channel

BLAUPUNKT BPS-E452 2 Way Car Speaker System User Manual -
WIRING

Blaupunkt Speakers wired in parallel to a single channel Total Impedance: 2 ohms x channel BLAUPUNKT BPS-E452 2 Way Car Speaker System User Manual -
WIRING

MOUNTING

NOTE: BLAUPUNKT strongly recommends that you operate your system at low volume levels prior to the complete installation of your BLAUPUNKT speakers.

CAUTION: Make sure that all of the speaker wiring is fully protected from cuts, tears or possible wear. Any short circuit caused from cuts, tears or wears, could severely damage the source unit or ampli er. Make sure all speaker wires easily reach the speaker terminals with no stress on the wires or connectors.

IMPORTANT: Never cut any metal that is an integral part of the vehicle’s safety or structural support system. If you are unsure of the importance of any components of your vehicle, it is recommended that you have your speaker professionally installed.

CHOOSING A LOCATION: It is always best to plan the complete installation prior to attempting to install any product. The routing of wires, power connections, and mounting location, should be planned rst. As with any car stereo installation, all work performance should be checked thoroughly and carefully prior to the operation of the system.

BLAUPUNKT Speakers are designed to t in almost any factory location. If at all possible, it is recommended that you use factory locations. This applies mostly to later model cars. For those earlier model cars, that do not have factory location or are limited to just front speakers, it is recommended that you choose a location with a sufficient amount of air space.

If there’s not enough air space, the woofer of the speaker may not reproduce low frequencies very well. It is recommended to mount the speakers in the door panels, kick panels, rear deck, etc. Ideally, the speakers should be mounted where it will be in an enclosed airspace. This allows for an extended bass response.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals