BLAUPUNKT BPS-X6530 3 Way Car Coaxial Speaker System User Manual
- June 15, 2024
- Blaupunkt
Table of Contents
BLAUPUNKT BPS-X6530 3 Way Car Coaxial Speaker System User Manual
MOUNTING
NOTE: BLAUPUNKT strongly recommends that you operate your system at low volume
levels prior
the complete installation of your BLAUPUNKT speakers.
CAUTION: Make sure that all of the speaker wiring is fully protected from
cuts, tears or possible
wear. Any short circuit caused from cuts, tears or wears, could severely
damage the source unit
or amplier. Make sure all speaker wires easily reach the speaker terminals
with no stress on the
wires or connectors.
IMPORTANT: Never cut any metal that is an integral part of the vehicle’s
safety or structural
support system. If you are unsure of the importance of any components of your
vehicle, it is
recommended that you have your speaker professionally installed.
CHOOSING A LOCATION: It is always best to plan the complete installation
prior to attempting to install any product. The routing of wires, power
connections, and mounting location, should be planned rst. As with any car
stereo installation, all work performance should be checked
throughly and carefully prior to the operation of the system.
BLAUPUNKT: Speakers are designed to t in almost any factory location. If
at all possible, it is
recommended that you use factory locations. This apply mostly to later mode
cars.
For those earlier model cars, that do not have factory location or are limited
to just front speaker,
it is recommended that you choose a location with a sufficient amount of air
space.
If there’s not enough air space, the woofer of the speaker may not reproduce
low frequencies very
well. It is recommended to mount the speakers in the door panels, kick panels,
rear deck, etc.
Ideally, the speakers should be mounted where it will be in an enclosed
airspace.
This allow for an extended bass response.
WIRING
Blaupunkt Speaker wired to a single channel Total Impedance: 4 ohms x channel
Blaupunkt Speakers wired in parallel to a single channel Total Impedance: 2
ohms x channel
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>