DECORATIVE CEILING TILES R32c Topkapi Palace Foam Glue Up Ceiling Tile Installation Guide
- June 15, 2024
- DECORATIVE CEILING TILES
Table of Contents
DECORATIVE CEILING TILES R32c Topkapi Palace Foam Glue Up Ceiling Tile
STYROFOAM CEILING TILES – Installation Guide
Required Tools
- Utility knife
- A measuring tape
- A caulk
- A pencil
- A gloves
- Sponge
- An adhesive ( Instant Grab #310 )
- Caulking gun
- Straight edge
- Chalk line
Ensure you have all the necessary materials from a local hardware or home improvement store before starting the project. When cutting ceiling tiles with a utility knife, be cautious to prevent injuries. Trim tiles securely on a flat surface.
-
Step 1. Prepare the surface
Styrofoam ceiling tiles can be installed on ceilings and walls covered with drywall, lime, lime-cement, dry plaster, chip-board, aerated concrete, masonry, silicates, and popcorned or textured ceiling finishes. When installing over any existing ceiling material, the surface should be dry, stable, even, hard, and free of any dust or debris. -
Step 2. Discovering the Central Spot
To achieve an aesthetically pleasing layout, it is recommended to begin installing your Styrofoam decorative tiles from the center of the room. If there is already a ceiling fan or light in this location, you can start there. Otherwise, you can use the string method to determine the room’s center. Stretch two strings diagonally across the ceiling from opposite corners, securing the ends with finish nails or with the assistance of a helper. Mark the intersection point of the strings to create two perpendicular lines, dividing the ceiling into four quadrants. -
Step 3. Applying Adhesive to Tiles
Apply 1 to 1 ½ inch thick mounds of mastic on the back of each tile. Adjust thickness based on surface type (porous or flat) and use initial tiles to determine the ideal amount. Place mastic mounds, 2 to 3 inches in diameter, at tile corners, center, and additional spots as needed. Press tiles onto the ceiling, allowing mastic to distribute evenly. Avoid excess mastic near edges to prevent overflow during installation. -
Step 4. Installing the First Tile
Measure and mark the center of each wall, considering any offsets or unique situations. Use a chalk line to snap a line through the marked centers, creating square lines as installation guides. Inspect the lines for accuracy before installing any tiles. Apply adhesive to the first tile’s back, align one corner with the marked center of the room, and ensure the edges follow the chalked lines. -
Step 5. Ensuring Adhesion and Spacing
Apply sufficient force to evenly spread the mastic while pressing each tile into place, avoiding damage to the surface. Install tiles in parallel rows, keeping the edges closely aligned. Consider snapping additional lines for tile width guidance, being cautious not to mark installed tiles. Exercise caution when trimming tiles at the room perimeter. -
Step 6. Final Caulking Touches
After completing the tile installation, use a caulking gun to apply caulk along the tile seams, focusing on areas with gaps for a seamless look. Practice caulking on spare tiles if you’re inexperienced before working on the finished ceiling. Apply caulk similar to grouting ceramic tiles, filling the excessive caulk, and smooth the bead with a clean finger promptly. Use a damp sponge to remove excess caulk, rinsing it frequently and wringing it thoroughly to prevent smudging the tiles.
NOTE!
- Avoid applying Styrofoam ceiling tiles over soft or unstable popcorn ceilings.
- If the popcorn ceiling falls into these categories or is questionable, remove it before tile installation.
- To remove popcorn, soak it with water and scrub it off the surface.
- When painting tiles, use white caulk; for pre-finished tiles, choose a matching or clear caulk.
- Wipe off excess caulk promptly before it dries to avoid difficult removal.
Decorative Ceiling Tiles, Inc.
References
- Ceiling Tiles, Panels, Beams, Moldings | Decorative Ceiling Tiles
- Ceiling Tiles, Panels, Beams, Moldings | Decorative Ceiling Tiles
- A la Maison Ceilings Instant Grab - Ceiling Tile, Wall Panel and Crown Molding Water Based Adhesive No. 310 - Pack of 6,White,AX310 : Tools & Home Improvement
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>