BROCK Electronics GS 001 W Gas Stove Instruction Manual
- June 4, 2024
- BROCK Electronics
Table of Contents
BROCK Electronics GS 001 W Gas Stove
GS 001 W
USER MANUAL
Thank you for choosing BROCK gas stove and we hope that it will serve you for long time. Carefully read the user manual and follow the instructions and conditions. Manufacturing plant is not liable for any damage, failures and accidents caused by the wrong exploitation made by customer.
CAUTION!
INTENDED TO BE USED ONLY OUTDOORS!
Notice the type of gas with gas stove is operating with. It is mentioned on
package.
After use, always turn off the gas supply!
Connecting the gas cylinder, use only special- reinforced gas pipe that is long enough to not allow pipes stretching.
Be careful to avoid getting burned by touching the top panel of the gas table as it gets very hot near the burner when in use.
Do not apply excessive pressure to the flame regulator and ON/OFF switch.
To avoid damage, do not place charcoal on the burners.
Do not allow the holes in the burners to become clogged.
Keep the gas table clean for better service and a longer operation life.
At night and when leaving the house, be sure to turn off not only the Flame regulator and
ON/OFF switch of the gas table, but also the main gas valve of gas bottle as well.
For better complete combustion, keep the burners clean.
Check the rubber gas hose which connect the gas cooker to the gas bottle regularly for wear or leak, it must be replaced occasionally. Keep it away from heat source and keep it clean.
Make sure that there are no inflammable objects near the gas table.
CAUTION!
Be sure to use a new rubber hose.Do not use a vinyl hose because it is
susceptible to heat and non-elastic.
Insert the rubber hose securely and fasten it tightly with a hose clip. After installation is complete, check that the pipes are properly connected using a soap test variation!
Flexible pipes must satisfy the following conditions:
- It may be present at a temperature of room temperature and not higher than 30 ° C;
- It is no longer than 1500mm;
- It can not be constrict;
- It should not be subjected to drawing or a force of;
- It should not be exposed to sharp edges and corners;
- It does not crack appeared cuts, burning feet pipe ends or the entire length,
- The material is not cured, it is still flexible,
- Fixing clamp is not corroded,
- The period of validity has not expired.
USE OF GAS STOVE
Be sure to use a new rubber hose. Do not use a vinyl hose because it is susceptible to heat and non-elastic. Insert the rubber hose securely and fasten it tightly with a hose clip. Open the main gas valve. Push the flame regulator and ON/OFF switch and turn it counters anticlockwise to the ON position,use burning torch on burner. To adjust the flame, turn the gas control knob to a suitable position between ON and OFF; be careful when turning the flame regulator toward OFF, as the flame may go out.
TECHNICAL INFORMATION
Small burner injector size| 0,75mm (Marked 0,75)| ****
---|---|---
Burner type| Single burner comprising a die cast aluminum alloy body
Aeration setting| 2 trapezoid – high (8mm), upper line (8mm), lower line
(10mm)
Inlet
connection| Connection to suit country of destitution
Gāzes tips| I3+(28-30/37)| I3B/P(30)
---|---|---
Siltuma ievade| ΣQn= 1.7 kW( 124g/h)
Gāzes spiediens| G30 pie 28-30mbar vai G31 pie 37 mbar| G30 un G31 pie
30 mbar
Iestatīšanas spiediens| Ka! augsta! k nora! dīt! s
Galvenā degļa inžektora izmērs| 0,68mm (atzīm! e! ts 0,68)
Mazā degļa inžektora izmērs| 0,75mm (atzīm! e! ts 0,75)
Degļa veids| Viens deglis, kam ir alumī!nija sakause! juma korpuss
Trademarks BROCK Electronics owner GTCL BALTIC
Phone: +371 67297762
E-mail: gtcl@gtcl.eu
www.brockgroup.eu
www.gtcl.eu
Technical Service: Tel. +371 28683856,
serviss@gtcl.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>