GOODYEAR F250 Shatterproof in Channel Window Deflectors Instruction Manual
- June 15, 2024
- GOODYEAR
Table of Contents
GOODYEAR F250 Shatterproof in Channel Window Deflectors
SIDE WINDOW DEFLECTORS
Before installing the deflectors, please read the manual.
Incorrect installation of deflectors can cause damage or injury
ATTENTION! IMPORTANT INFORMATION!
ATTENTION! Read the installation instructions carefully and follow all POINTS in the text! Incorrectly installed deflectors can be dangerous.
- Deactivate the safety features of the vehicle if they do not allow you to close the window and make sure to check the car instruction manual.
- After installing the deflectors, leave the car windows closed for 72 hours.
- We strongly recommend installing the deflectors at temperatures between 62.5°F/l 7°C and 77°F/25°C.
- IMPORTANT INFORMATION! Clean the grease off the installation surface with a supplied alcohol wipe. If the deflector installation process is not followed, the manufacturer does not guarantee the secure installation of the product.
COMPLETE SET
4 Piece Set (2 Piece Set) (the product may differ from the illustration in the instructions)
ATTENTION! Protective film, DO NOT REMOVE!
HOW TO INSTALL THE SIDE WINDOW DEFLECTORS
- Deflector frame
- Back section of deflector
- Front section of deflector
FRONT DEFLECTORS
REAR DEFLECTORS
FRONT DEFLECTORS
-
Make sure the car windows are clean and dry. Next, lower the side windows completely and clean the grease off the inner surface of the window channel with an alcohol wipe.
-
Place the metal bracket onto the lower rubber seal as close to the front window frame as possible.
-
Lower the front section of the deflector onto the metal bracket as shown in the illustration.
-
Bending the center part of the deflector outwards, insert the rear section of the deflector into the channel leaving a gap above it.
-
Immediately after installing the deflector, adjust its position by carefully pulling it outwards.
-
Raise the window until it touches the deflector.
carefully pulling the deflector outwards, roll up the window _with abrupt movements. Repeat this action 4-5 times, then leave the window closed. -
Place a small section of the transparent protective tape, included with the complete set, onto the flat surface of the metal bracket as shown in the illustration.
-
Remove the protective liner from the tape on the deflector.
-
Shift the deflector forward, fitting the deflector frame into the channel completely. Make sure the deflector is placed above the lower window frame.
-
Starting with the front section of the deflector, insert it into the window channel.
-
To ensure the best installation of the deflector and the best adhesion between the tape and the surface of the rubber seal, it is strongly recommended that you use the plastic blade, moving it slowly between the window’s inner rubber seal and the deflector.
-
Repeat points 1.1 to 1.11 on the opposite side of the vehicle.
CONGRATULATIONS!
We hope you enjoy the appearance of your unique and durable Deflectors!
- If you have any questions about warranty, technical aid, or requests for missing (lost) parts, do not hesitate to use our website: www.goodyear-deflectors.com
- For assistance please contact customer service by phone at+ 1 888 311 11 25 or by email at help@goodyear-deflectors.com
Goodyear (and Winged Foot Design) and Blimp Design are trademarks of The Goodyear Tire & Rubber Company used under license by PROFIMPORT LLC, Building 3, Mayakovskogo Str. 1 A, Ryazan, Russia. Copyright 2021 The Goodyear Tire & Rubber Company.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>