Refoss RQBK7 Garage Door Remote Instruction Manual
- June 14, 2024
- Refoss
Table of Contents
Programming Introduction
Of 390M Garage Door remote
RQBK7
Putting Opener into Programming Mode
New Genie® Openers
- Press and hold the program button until the round LED turns blue, thenrelease.
- The round LED wills ing purple.
Proceed to step 2.
- Press & Release Learn Code button once. The red LED will begin to flash. Proceed to step 2.
Programming a Remote to your Opener
NOTE: Once in programming mode, you will have approximately 30 seconds to
perform this step.
Note: While programing remote buttons, stand atleast 5 feet away from the
opener. This ensures you have proper comm unication between the j’,_ remote
and the opener.
- Slowly press and release the remote button of your choice two times. The opener LEDs will flash and go off, indicating you have successfully programmed your remote.
- Press and release the same button a third time and door will open or close. It is possible to press the remote button too quickly or lightly. If the LEDs do not go OFF, press the remote button several more times to achieve confirmation.
Lost or Stolen Remote/Erasing all Remotes
New Genie® Openers
- Press and hold the program button until the round LED turns blue, then release.
- Press and hold the Up(+) Down (-)buttons at the same time, until the both LEDs flash blue ‘ = and go OFF. Genie® Openers and External Recaivers Manufactured between 1555 10 2011 Toeraseall remote devices from all other types of Genie® openers, Press and hold the Learn Code Button until the LED stops blinking. Start at step 1 to reprogram your remotes.
NOTE: Clearing remote control memory fromthe power head will clear ALL pro- grammedremotes andkeypads. Your opener will no longer recognize any signal fromany remcte device, induding a missing remcte device.
Specifications
Of 390M Garage Door remote
Specifications
Items| Performance| Notes
Frequency| 390MHZ|
Maximum transmit power| 10dBm| Transmitter
Modulation| OOK|
Standy Current| 100nA|
Battery| 12V 27A|
Size| 875315 MM| RQBK7
Operating temperature| -20-65°C|
storage temperature| -40-85°C|
FCC compliance statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Caution: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>