D-Link DWL-G650 AirPlus XTREMEG Wireless Cardbus Adapter Quick Installation Guide

D-Link DWL-G650 AirPlus XTREMEG Wireless Cardbus Adapter

This product works with the following operating system software: Windows XP, Windows 2000, Windows Me, Windows 98SE

Before You Begin

You must have at least the following:

• A laptop computer with an available 32-bit Cardbus slot
• At least a 300 MHz processor and 32MB of memory
• The Cardbus Controller is properly installed and working in the laptop computer
• An 802.11g or 802.11b Access Point (for Infrastructure Mode) or another 802.11g or 802.11b wireless adapter (for Ad-Hoc; Peer-to-Peer networking mode.)

Check Your Package Contents

These are the items included with your DWL-G650 purchase:

If any of the above items are missing, please contact your reseller.

Insert the D-Link CD-ROM Into Your Computer

Turn on the computer and Insert the D- Link AirPlus XtremeG DWL-G650 Driver CD in the CD-ROM drive. The step-by-step instructions that follow are shown in Windows XP. The steps and screens are similar for the other Windows operating systems
Warning: Do NOT install the DWL-G650 Cardbus Adapter into your computer before installing the driver software from the D-Link CD!

The Install Screen will appear.

If the CD Autorun function does not automatically start on your computer, type “D:\Driver\Setup.exe.” If it does start, proceed to the next screen.

Shut down your computer
Remember to leave the Driver CD in the CD-ROM drive.

Installing the DWL-G650 Wireless Cardbus Adapter in Your Computer

• A. Make sure to turn off the laptop computer.

• B. Locate the cardbus slot on your laptop computer. C. Gently insert the DWL-G650 into the cardbus slot in your laptop computer.

• C. Gently insert the DWL-G650 into the cardbus slot in your laptop computer.

Restart Your Computer

When you restart your computer this Found New Hardware Wizard (Windows XP) screen may appear:

For Windows XP: This Hardware Installation alert screen may appear after the desktop computer restarts.

Warning: For Windows 2000, this Digital Signature Not Found screen may appear after your computer restarts.

Warning: The D-Link Driver software for this device is undergoing Windows Logo testing. Microsoft certification is pending!

Your Installation is Complete!

After you have continued in Windows XP, 2000, Me, or 98SE, the D-Link DWL-G650 Configuration Utility will automatically start and the utility icon will appear in the bottom right hand corner of the desktop screen (systray). If this icon appears GREEN, then you have successfully installed the DWL-G650, are connected to a wireless network and are ready to communicate!

Appendix

For Windows XP, if you wish to use the Xtreme G utility, please do the following steps.

Using the Configuration Utility

• A. Status: Displays the MAC Address of the Access Point that is associated with the DWL-G650.

• B. SSID: The Service Set Identifier is the name assigned to the wireless network. The factory SSID setting is set to default.

• C. Frequency: Displays the current frequency used by the adapter.

• D. Wireless Mode: The factory setting is set to Infrastructure. Ad hoc mode is used for Peer-to-Peer networking.

• E. Encryption: Displays the current encryption status of the wireless connection.

• F. Tx Rate: The default rate is automatically determined by the DWL-G650 depending on the distance from the access point.

• G. Channel: Displays the channel information. By default, the channel is set to 6. Please note that the DWL-G650 will automatically adjust channel depending on the access point.

• I. Packet Count: Graphically displays the statistics of data transmitted and received.

• H. Signal Strength: This represents the wireless signal quality and strength between the access point and the DWL-G650. The percentage coincides with the graphical bar.
  

• J. SSID: The Service Set Identifier is the name assigned to the wireless network. The factory SSID setting is set to default. Make changes here to match the SSID on existing wireless router or access point.

• K. Wireless Mode: The factory setting is set to Infrastructure. Ad hoc mode is used for Peer-to-Peer networking.

• L. Data Encryption: The default setting is set to Disabled. The adapter supports WEP when encryption is enabled.

• M. Authentication: You can specify the authentication mode for the wireless network. The default setting is set to Open.

• N. Key Length: When encryption is enabled, you will have the option to specify the level and key format of the encryption used. Select the appropriate Key Index : 1-4 and enter ACSII or hexadecimal digits in the appropriate field.

• O. IEEE 802.1x: When encryption is enabled, you will have the option to specify the level and key format of the encryption used. Select the appropriate Key Index : 1-4 and enter ACSII or hexadecimal digits in the appropriate field.
  

IP Address Configuration

To connect to a network, make sure the proper network settings are configured for DWL-G650.

For Microsoft Windows XP
Go to Start > Right-click on My Network Places > select Properties > Double-click on the Network Connection associated with the DWL-G650.

Dynamic IP address setup
Used when a DHCP server is available on the local network. (i.e. router)

Static IP address setup
Used when a DHCP server is not available on the local network.

Input a static IP address in the same range as the wireless router or access point.

Technical Support

You can find software updates and user documentation on the D-Link website. D-Link provides free technical support for customers within the United States and within Canada for the duration of the warranty period on this product. U.S. and Canadian customers can contact D-Link technical support through our website, or by phone. Tech Support for customers within the United States:

• D-Link Technical Support over the Telephone:877-453-5465 24 hours a day, seven days a week.
• D-Link Technical Support over the Internet: http://support.dlink.com
• Email:support@dlink.com

FAQs

What is the D-Link DWL-G650 AirPlus XTREMEG?

It's a Wireless Cardbus Adapter designed for laptops.

Which wireless standards does the DWL-G650 support?

It supports IEEE 802.11g and is backward compatible with 802.11b.

What type of interface does the DWL-G650 use?

It uses a Cardbus (PCMCIA Type II) interface.

What are the data transfer rates of this adapter?

The adapter offers speeds up to 54 Mbps.

Is the DWL-G650 suitable for streaming and gaming?

Yes, its high-speed data transfer makes it suitable for streaming and gaming.

What frequency does the DWL-G650 operate at?

It operates in the 2.4 GHz frequency band.

Does the DWL-G650 feature any security protocols?

Yes, it supports WPA and WEP encryption for secure data transmission.

How is the antenna designed in the DWL-G650?

It has an integrated internal antenna.

Is the adapter easy to install?

Yes, it features a plug-and-play setup for easy installation.

Can the DWL-G650 be used with any laptop?

It can be used with laptops that have a Cardbus slot.

Are drivers or software required for the DWL-G650?

It comes with necessary drivers and software for configuration.

Where can I purchase the D-Link DWL-G650?

It's available at electronics stores and online retailers.

References PDF:D-Link DWL-G650 AirPlus XTREMEG Wireless Cardbus Adapter – Device.report

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>