OREiN SOL-HX-S5.1 Solar Outdoor Light with Motion Sensor User Guide

OREiN SOL-HX-S5.1 Solar Outdoor Light with Motion Sensor

Please read this instruction before installing the product please keep this user manual for future reference.

INSTALLATION

1. Install on brick or concrete wall, mark the installing position, using an electric drill to drill two holes. Hammer the plastic plugs into the holes. Using a screwdriver to drive firmly.
2. Install on a wooden wall, using the same way as above but no need to use plastic plugs.
3. Adjust the solar panel direction and the joint direction.

WIDELY USED
Our products are mainly used for Wall Lighting, Garden Lighting, House Lighting, Garage Lighting, Building Lighting, Advertisement Lighting etc.

PAY ATTENTION

1. This is a solar-powered lamp, please install it in a place where it can get enough sunlight in the daytime.
2. The Li-ion battery can not be fully charged for safety reasons during transportation, when you use your new solar lamp pls put it under the sunlight for 5-6 hours to charge it.
3. You should know that the lighting time depends on the sunlight received in the daytime and other weather conditions.
4. when it runs out of battery the lamp will not work until the next sunny day that can charge it.
5. The lamp contains an intelligent IC control inside with over-charge and over-discharge protection.
6. The battery inside can not be replaced.

SPECIFICATIONS

Installation Type

Working Modes

1. Press the red button the first time the light will blink once and keep high brightness in the 20S, then enter Mode1: When people pass by, the light will be in high brightness for 20 seconds and then switch when no detection.
2. Press the red button a second time, light will blink twice and keep high brightness in the 20S, then enter Mode2: When people
3. pass by, the light will be in high brightness for 20 seconds and then keep the low brightness.
4. Press the red button a third time light will blink three times and then enter Mode3: Keep low brightness at night and the PIR sensor will not work with this mode.
5. Press the red button a fourth time, and turn the light.

FCC Statement

This device complies with Part 15 of FCC Rules.

Operation is subject to the following two conditions

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>