SUPERATV IN-ROOF-TR-500S Tracker 500S Tinted Roof Instruction Manual
- June 14, 2024
- SUPERATV
Table of Contents
2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427
IN-ROOF-TR-500S Tracker 500S Tinted Roof
INSTALLATION INSTRUCTIONS
Roof: for Tracker® 500s
– SuperATV does not recommend keeping Roof installed while transporting on an
open air trailer. Remove or secure with straps.
– This item is not returnable if the protective film has been removed.
– Test fit to the cage to confirm fitment before removing film.
– Do not discard packaging until product has been successfully installed.
Roof Cleaning:
– Do not use Rain-X® , Plexus® or any other protector, wax, or polish.
– Do not use window cleaning fluids (Windex, 409, etc) or any solvents
(gasoline, denatured alcohol, acetone, etc).
– Never use abrasive cleaners, abrasive pads, or gritty cloths.
- Thoroughly rinse Roof to float off dirt and mud.
- Using a soft cloth, or microfiber cloth, clean Roof with warm water and a gentle detergent. Baby shampoo, rubbing alcohol, or hand washing soap can also be used.
- To prevent water spots, use a chamois to blot Roof dry.
Liability Statement
SuperATV’s® products are designed to best fit user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts
will void any warranty provided by SuperATV® and is not recommended.
SuperATV’s® products could interfere with other aftermarket accessories. If
user has aftermarket products on machine, contact SuperATV® to verify that
they will work together. Although SuperATV® has thousands of satisfied
customers, user should be aware that installing lift kits, long travel, or
suspension kits, tires, etc. will change the ride of machine and may increase
maintenance and part wear. Operating any off-road machine while, or after,
consuming alcohol and/or drugs increases risk of bodily harm or death. No
warranty or representation is made as to this product’s ability to protect
user from severe injury or death. SuperATV® urges operators and occupants to
wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV® products, user agrees that should
damages occur, SuperATV® will not be held responsible for loss of time, use,
labor fees, replacement parts, or freight charges. SuperATV® , nor any 3rd
party, will not be held responsible for any direct, indirect, incidental,
special, or consequential damages that result from any product purchased from
SuperATV® . The total liability of seller to user for all damages, losses, and
causes of action, if any, shall not exceed the total purchase price paid for
the product that gave rise to the claim. SuperATV® will warranty only parts
provided by SuperATV® . Any damage or problems with OEM housings, bearings,
seals, or other manufacturers’ products will not be covered by SuperATV ® .
SuperATV® parts and products are not warrantied if item was not installed
properly, misused, or modified.
Installing, adding, modifying, or fabricating any factory or aftermarket
product to your ATV/UTV may violate certain local, state, and federal laws. Be
advised that laws vary depending on town, city, county, state, etc. Use of
certain products on public streets, roads, or highways may be in violation
law. The Buyer is solely and exclusively legally and personally responsible
for any violation of the law by the installation or use of the product. You
must abide by all local, state, and federal laws, including but not limited to
vehicle safety, traffic laws, and ordinances. It is your responsibility to
know the laws and how they apply to you.
The Buyer is responsible to fully understand the capability and limitations of
his/her vehicle according to manufacturer specifications, warnings and
instructions and agrees to hold SuperATV® harmless from any damage resulting
from failure to adhere to such specifications, warnings and/ or instructions.
The Buyer is also responsible to obey all applicable federal, state, and local
laws and ordinances when operating his/her vehicle while using this product,
and the Buyer agrees to hold SuperATV® harmless from any
violation thereof.
Use hand tools only when assembling.
Do not use power tools.
Install Gasket to Roof – Rear as shown.
Join Front and Rear to Bracket with hardware shown; tighten. After joining,
install Seal to sides in location shown.
To ease installation, soak Seal in hot water before cutting or installing to
increase flexibility.
Install Clamps around Cage in locations shown. Secure Roof – Rear to Clamps
with hardware shown; do not tighten. Install Clamps around Cage in locations
shown. Secure Roof to Clamps with hardware shown; do not tighten.
Install Clamps around Cage in locations shown. Secure Roof to Clamps with
hardware shown; do not tighten. Align Roof to machine and tighten all
hardware.
Need help with your installation?
sales@superatv.com
1-855-743-3427
www.superatv.com
8:00am – 8:00pm EST M-Th
8:00am – 7:00pm EST Friday
9:00am – 2:00pm EST Saturday
Read instructions and view illustrations before beginning.
Thank You
For Choosing
IN-RWS-TR-500S 7/15/2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>