AIKELA AP004 Wireless Lavalier Microphones User Manual
- June 14, 2024
- AIKELA
Table of Contents
AIKELA AP004 Wireless Lavalier Microphones User Manual
Any questions pis contact:[email protected]
Introduction
Thanks for choosing our product.
This product is a smart wireless microphone that provides professional-grade recording output. Plug and play, no app required. Multiple uses: It can be used in online livestreaming, video Vlog shooting, program interview, recording, video teaching and other occasions.
The wireless Microphone consists of two parts, one is Microphone
transmitter*2, the other one is Lightning receiver.
(See as below picture)
ID Diagram
- Windproof net
- Microphone indicator
- Microphone Type-C charging port
- Microphone clip
- Switch key
- Microphone reset key
- Lightning port to connect phone
- Receiver indicator
- Reset key of receiver
- Lightning port of receiver
- The function of above (10) will be specifically explained later.
How to use
Step1 :Plug the receiver into your device, red light on the receiver flashes slowly.
Special Note:
For the use of (10) Lightning port: there is no battery in Lightning receiver,
and no need to recharge during live streaming. If the phone is running out of
power during live streaming, it can be recharged directly through (10)
Lightning port.
Packing List
- Microphone transmitter
- Lightning receiver
- Type-C charging cable
- User manual
- Storage bag
About UI
Q&A
Q: Why microphone can not connect with receiver?
A: Please factory reset as below instructions:
1. Power on both microphone and receiver (The receiver needs to be plugged
into your device)
2. Poke the reset key twice quickly by a pin on both microphone and receiver,
indicator lights flashes quickly, then they will auto pairing and indicator
lights stays on.
Q: What should I do if there is no sound in the recorded video?
A: Please confirm below 4 situations:
- Confirm whether the connection is successful: The indicator lights of the microphone and receiver are always on, which means the connection is successful. Only when the connection is successful can the recording sound be started.
- This microphone supports Mute on (Blue light is on microphone) and Mute off (green light is on microphone), make sure the green indicator light of microphone stays on when recording.
- You need to unplug the receiver from the phone to hear the sound after recording is done
- Confirm whether the phone volume is not at 0, and adjust properly.
Q: Do the microphone need to be charged?
A: Microphone need to be charged with included Type-C charging cable when it’s
running out of power. You may see blue light flashes on the microphone.
Q: Can I turn off the noise reduction function of the microphone?
A: No. The microphone has a built-in noise reduction chip with Al Intelligent
noise reduction technology to enhance your sound quality which can’t be
switched off.
Q: Can it be used as a amplifier?
A:lt is a microphone to pick up sound only, not a loudspeaker.
Any questions pis contact:[email protected]
