SATCO 64-145 Pro Color Changing RGB Smart Tape Light Instruction Manual

SATCO 64-145 Pro Color Changing RGB Smart Tape Light Instruction Manual

INSTALLATION AND SAFETY INSTRUCTIONS

IMPORTANT: Read before installing fixture. Retain for future reference

WARNING: Risk of Fire or Electric Shock

• This tape lighting is only intended to be used with the products provided in the kit.
• Installation requires knowledge of luminaries electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
• To reduce risk of fire and over-heating, secure all connections.
• TURN OFF the electrical power before proceeding.
• The electrical rating of this product is 120V/60Hz.
• The grounding and banding of the system shall be done in accordance with National Electric Code (NEC) Article 600 and local codes.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Do not damage any PCB conductive parts, squeeze or fold the LED tape light when installing.
• Pay attention to positive and negative polarities before installation, otherwise the LED tape light may be damaged.
• Prevent static electricity when installing. Avoid damp or wet exposure.
• This device is not intended for use with emergency exits.

CUTTING
Applies to indoor models only 64-100, 64-110, 64-111, 64-120, 64-121, 64-130, 64-131, 64-132, 64-133, 64-134, 64-135.

• Always disconnect the power supply before cutting. LED strips can be cut as indicated in diagram.

Indoor Installation
Applies to models 64-100, 64-110, 64-111, 64-120, 64-121, 64-130, 64-131, 64-132, 64-133, 64-134, 64-135.

STEP 1: Clean surfaces carefully (free from grease and dust) before installing to ensure that the double sided tape or adhesive sticks properly to the surface. Wood, powder-coated, structured surfaces, glass, stainless steel etc. are not recommended locations.

STEP 2 : Gently peel off the tape, the adhesive tape may tear by over stretching.

STEP 3: Wearing an anti-static ring, gently press PCB areas. Do not press down on the actual LEDs.

STEP 4: Be careful to not step on the reel if you unreel the entire strip before installation.

Outdoor Installation

Applies to models 64-140, 64-141, 64-142, 64-143, 64-144, 64-145. Use included brackets to install the tape. There is no double-sided adhesive with these models

CONNECTIONS

STEP 1: Align white arrow on the controller’s cable to [ ] symbol on LED strip.

STEP 2: Connect controller to the power supply or Junction Box.

NOTE: Actual controller appearance may vary.

Wiring Diagram

STEP 3A: Plug the power supply into a power outlet.

STEP 3B: For Junction Box, shut OFF power at the circuit breaker. Connect wires as shown in wiring diagram above. Make sure all wire connectors are secure. After wires are connected, tuck them carefully inside the Junction Box and turn ON power

Operation

Applies to models 64-140, 64-141, 64-142, 64-143, 64-144, 64-145. Use included brackets to install the tape. There is no double-sided adhesive with these models.
Use the remote control or Starfish APP to control the light strip; such as to turn on and off, brightness and color change.

Manual Control by 3 Buttons & IR Remote Control

C Adjust Brightness/Speed

Press one time ON/OFF. To reset and put into network pairing mode, press and hold for 5 seconds
M Change mode type (8 mode options)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>