reolink CX410 4MP PoE Security Camera Outdoor Instruction Manual

**reolink CX410 4MP PoE Security Camera Outdoor Instruction Manual

**

What’s in the Box

Camera

Waterproof Lid

Ethernet Cable

Quick Start Guide

Surveillance Sign

Mounting Hole Template

Pack of Screws

Camera Introduction

1. Micro SD Card Slot
   

2. Mount
   

3. Spotlight
   

4. Lens
   

5. Built-in Mic
   

6. Speaker
   

7. Waterproof Lid
   

8. Network Cable
   

9. Reset Button
   

10. Press for about 10 seconds to
    

11. restore the device to factory settings.
    

12. Power Port (Optional)
    

 Connection Diagram

Before using the camera, please connect your camera as instructed
below to finish initial setup.

1.  Connect the camera to a Reolink NVR (not included) with an Ethernet cable.
2.  Connect the NVR to your router, and then power on the NVR.

NOTE : The camera should be powered with a 12V DC adapter or a PoE powering device such as
PoE injector, PoE switch or Reolink NVR (not included in the package)

 You may also connect the camera to a PoE switch or PoE injector.

Set up the Camera

Download and Launch the Relinks App or Client software, and follow the onscreen instructions to
finish initial setup

On Smartphone
****
Scan to download the Relink App.

On PC
****
Download path of the Relink Client

NOTE : If you are connecting the camera to a Relink PoE NVR, please set up the camera via the
NVR interface

Mount the Camera

Installation Tips

• Do not face the camera towards any light sources.
• Do not point the camera towards a glass window. Or, it may result in poor image quality because of the window glare by infrared LEDs, ambient lights or status lights.
• Do not place the camera in a shaded area and point it towards a well-lit area. Or, it may result in poor image quality. To ensure best image quality, the lighting condition for both the camera and the capture object shall be the same.
• To ensure better image quality, it’s recommended to clean the lens with a soft cloth from time to time.
• Make sure the power ports are not directly exposed to water or moisture and not blocked by dirt or other elements.
• With IP waterproof ratings, the camera can work properly under conditions like rain and snow. However, it doesn’t mean the camera can work underwater.
• Do not install the camera at places where rain and snow can hit the lens directly.
• The camera may work in extreme cold conditions as low as -25°C. Because when it is powered
  on, the camera will produce heat. You may power on the camera indoors for a few minutes before installing it outdoors.

Install the Camera

  Drill holes in accordance with the mounting hole template.

NOTE : Use the drywall anchors included in the package if needed.

Install the mount base with the mounting screws included in the package

NOTE : Run the cable through the cable notch on the mount bas

To get the best field of view, loosen the adjustment knob on security mount and turn the camera.

Stiffen the adjustment knob to lock the camera.

Troubleshooting

Camera is Not Powering On

If your camera is not powering on, please try the following solutions:

• Make sure your camera is powered properly. The PoE camera should be powered by a PoE
  switch/injector, the Reolink NVR or a 12V power adapter.

• If the camera is connected to a PoE device as listed above, connect the camera to another PoE
  port and see if the camera will power on.

• Try again with another Ethernet cable.

If these won’t work, please contact Reolink Support.

Picture is not Clear

If the picture from the camera is not clear, please try the following solutions:

• Check the camera lens for dirt, dust or spiderwebs, please clean the lens with a soft, clean cloth.
• Point the camera to a well-lit area, the lighting condition will affect the picture quality a lot.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out again.

If these won’t work, please contact Reolink Support.

Spotlight is not On

If the spotlight on your camera is not on, please try the following solutions:

• Ensure the spotlight is enabled under Device Settings page via Reolink App/Client.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out the spotlight light settings again.

If these won’t work, please contact Reolink Support.

Specifications

General

Size: 67×187 mm
Weight: 467g

Operating Temperature: -10°C~+55°C (14°F~131°F)
Operating Humidity: 10%~90%

Notification of Compliance

CE Declaration of Conformity

Reolink declares that this device is in compliance with the essential requirements and other relevant provisions of EMC Directive 2014/30/EU and LVD 2014/35/EU

UKCA Declaration of Conformity

Relink declares that this product is in compliance with Electromagnetic Compatibility Regulations 2016 and Electrical Equipment Safety Regulations 2016.

FCC Compliance Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con

ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or moreof the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

ISED Compliance Statements

This Class B digital apparatus complies with Canadian ICES-003. Cat apparel numérique de la classe B est conformed à la norme NMB-003 du Canada

Correct Disposal of This Product

This marking indicates that this product should not be disposed with other household wastes. throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

Limited Warranty

his product comes with a 2-year limited warranty that is valid only if purchased from Reolink Official Store or a Relink authorized resell

Terms and Privacy

Use of the product is subject to your agreement to the Terms of Service and Privacy Policy at relink Keep out of reach of children.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>